Here is the specs on the cam (DPR) i have been running in my 3.0 puller. 470* intake 459*exh 112*centerline 232 dur intake 230 dur on the exh cam is retarted 3.2*
I can't get the egt down and have gone threw three sets of heads. the first two had oversize intake valves and melted the exh into...
Diesel TV 2012.mov
http://www.youtube.com/watch?v=SqmtxMZJTgs
Diesel Television will be covering diesel motorsports across the United States and Canada.
I am thinking of running South Bend Clutch 3 disk Slipper they have for sled pulling. I Don't want to spend half the season trying to set up a full blown slipper clutch. What do you guys think i know not to many have a slipper style Clutch i know Yellow Jacket runs one and seem to get it dialed...
Who plans on or are currently building a odl truck this winter?
I would like to but the cost can be crazy ..
$5000..Clutch & bellhousing
$4500..drop box & reverser
Then upgrade your dana & rockwell...a guy could drop 15 grand in a hurry.
I Need to find some used parts.
Here's what the trans is doing then throws a p0722 output speed sensor code. When i put the truck in any gear and move it without much speed it will go into neutral till i move the gear selector then it goes right back into gear. Now if i keep my foot on the brake even just a little it will not...
Here is a vid.http://s290.photobucket.com/albums/ll271/jimdmax/?action=view¤t=MVI_1508.flv
This is a non stoker motor on fuel only. Built by Curtis, Tuned by Mark B. & The rest my me and my friends.
I have a built dual cp motor that i can not get started i tried removing the belt and hooking the stock cp back up and get the same thing 26106 rail pressure when i crank the motor. The GPM is removed and the return rate sender on the return line was removed but i plugged the sender back in and...
When i plug my V2 into my OBD II port it does not start up it says no connection to ECM tried it on two different trucks same thing. I am thinking it will need to be repaired, But was wondering if anyone else had this problem?
i am putting a new AAM torsen posi unit in. The pinion wasn't removed i know i have to set the preload my ? is do i have to adjust or check the backlash?
thanks jim
Badger S.S.D. pull fri 6/6 7:00 Union grove Wi.
6/7 sat. is the NADM pull 7:00 Union Grove Wi.
Badger S.S.D. trucks pull 6/7 At 7:00 in Deerfield Wi.
jim
Broke my G80 what is out there for aftermarket still a street truck so don't think i want a spool. Hows that dodge helical posi any buddy have one?
jim
I bought this charger used. The fin at 6:00 in the pic has the corner fin bent out some is this a problem or not. Was told it was only ran a short while. And in good shape.
...~jim~...