Search results

Search the forum Search Articles
  1. JoeyD

    NP246/266 custom build

    I have a project that I want to use with the np149 behind a 6l90, not as much power as your running though.
  2. JoeyD

    Tailgate alignment

    Is it possible the tailgate is twisted or something?
  3. JoeyD

    Chevrolet 1500 diesel ?

    When will the release the power and towing numbers?
  4. JoeyD

    L5P tapping/knocking noise when coasting???

    My 16 van does it and was concerning but I guess not.
    • JoeyD
    • Post #64
    • Forum: L5P
  5. JoeyD

    20w-50 oil

    Has anyone tried this Amsoil?
  6. JoeyD

    Vehicle Hoist

    I’d buy a Mohawk lift, look on there site and compare how they are made vs most others.
  7. JoeyD

    Anti seize

    I use this on everything I expect to come apart again, Wurth nickel anti seize
  8. JoeyD

    20w-50 oil

    Has anyone with lower than liked pressure checked oil temps?
  9. JoeyD

    New guy with van addiction

    All the duramax vans had the Dana 70s up until they switched back to the old 14bolt 10.5. I forget the year but maybe 12 or 13
  10. JoeyD

    Question: Traction bar mounting location?

    You need some flex built into it. This is from off-road design but you could make it yourself
  11. JoeyD

    Used frame or rolling chassis

    Road trip time.
  12. JoeyD

    Brand New Z06 Kill

    Those are 650 hp cars low 11’s no problem and 0-150 in 17 seconds.
  13. JoeyD

    1971 Chevelle Duramax Swap and Build

    I want to do this to my 71, I have an 06 Dmax van I want to use as a donor. I can’t wait to see more pics
  14. JoeyD

    ABs on a 06 with a sas

    Call WFO concepts, they have a bracket to keep your GM calipers and rotors as we'll as the ABS.
  15. JoeyD

    Spacer gap?

    They do make hub centric spacers.
  16. JoeyD

    Rear End Seals Replacement

    I usually torque it a few times to make sure it's seated, also make sure your spinning it while your doing it.
  17. JoeyD

    Trading a delete LML.

    Why would you not be allowed to put the stock exhaust back on?
  18. JoeyD

    Rear Hub Assembly Question

    You need to set the bearings to 50ftlbs while spinning the hub to seat everything properly, then back it off and put it hand tight. There are plenty of you tube videos of it or better descriptions online if you need it.
  19. JoeyD

    Rear Hub Assembly Question

    The seal doesn't have any effect on the bearing movement after installation and being torqued properly. Stop driving and take it apart and see what's wrong.
  20. JoeyD

    Mahle monotherm pistons

    Has anyone seen these yet, or are they even available?
Top Bottom