Hate to be the remote repair guy but I’m confused on this one. If you read my sob story in the other thread I’m trying to diagnose a no crank/no start.
My question is what controls the wait to start light? I don’t see GPC module in the starting and charging diagram. Ecm? When I turn key I don’t get a wait to start light or check engine light like normal. Only getting battery, security and brake light.
I have 12v at 40a ign fuse and at the relay. Starter turns over if you jump it. I replaced relay just to make sure. Have checked all the wiring and only thing I could find was melted wire loom under hot side intercooler pipe but the wires were fine. PRND321 shows the line under it and moves with the shifter.
Appreciate the help.
My question is what controls the wait to start light? I don’t see GPC module in the starting and charging diagram. Ecm? When I turn key I don’t get a wait to start light or check engine light like normal. Only getting battery, security and brake light.
I have 12v at 40a ign fuse and at the relay. Starter turns over if you jump it. I replaced relay just to make sure. Have checked all the wiring and only thing I could find was melted wire loom under hot side intercooler pipe but the wires were fine. PRND321 shows the line under it and moves with the shifter.
Appreciate the help.