Search results

Search the forum Search Articles
  1. R

    ? You May be right, we May be crazy...? -- May '25 Chat

    And Trump made the appointment!
  2. R

    IMS leaking trans fluid from pins

    Internal harness needed. That's where the seal is.
  3. R

    Leaf Spring Replacement/Upgrade

    I was happy with the work that General Spring did on my truck. I had them add a leaf to an existing pack and re-arch the existing spring and replace the u-bolts with new HDs.
  4. R

    Bought, wrecked, rebuilding a 2009 LMM

    I have some of the correct o-rings at home. Will be back at the end of nexxt week if you want to wait.
  5. R

    April '25 Chat -- We wont get fooled again!

    https://www.gmfuelpumplitigation.com/
  6. R

    p0238 code

    Some basic information about the code https://www.dtcdecode.com/Chevrolet/P0238
  7. R

    Help w Regen

    You never know who you are dealing with. I just try to provide information, not decide the capabilities of those who post about problems.
  8. R

    Help w Regen

    Maybe something in this https://www.duramaxforum.com/threads/diy-indirect-injector-replacement-p24a0.935442/
  9. R

    Crank NO Start 2002 2500HD LB7

    Some info attached
  10. R

    Power wash engine bay

    Keep that washer nozzle far away from any electrical connector.
  11. R

    Many emissions-related codes - 2.8 LWN

    https://www.dtcdecode.com/Chevrolet/P2002
  12. R

    Fuel sender replacement

    A variation is to loosen the bolts maybe 1/3 of the way keeping the nuts on on the passenger side of the bed and remove all the others. Then, jack up the driver's side of the bed and brace it up in a working position like your life depends on it, because it does That gives you access to the top...
  13. R

    Bought, wrecked, rebuilding a 2009 LMM

    This?
  14. R

    Bought, wrecked, rebuilding a 2009 LMM

    The BCM start messages via CanBus, not straight wire to the ECM, ECM checks to see if it's ok to run the starter (not in gear, etc). I have no idea within the BCM what happens but as long as you hold the key in START, the starter will run. To me that says it's continuous
  15. R

    L5p ecm pinout.

    GM UPFITTER .com Boby Builder section has ECM prints, maybe not your year
  16. R

    Some information on Tuning

    https://drive.google.com/file/d/13PsSZVly8sAhDN7y6mZZCfEHPim1z_9X/view?pli=1
  17. R

    After starter replacement no crank

    Verify the ING A and CRANK FUSE fuses are good and both are receiving B+ power
  18. R

    L5P will barely start, then die Please Help

    Wow - you are quite the worker!
  19. R

    2013 LML Reverse Only, No forward

    A -40 reading means that the temp sensor is unplugged/disconnected, missing ground, etc I don't see why that would be your problem though.
  20. R

    Killswitch Options & Opinions

    Anyone give a thought to addressing the ground side of required-to-start circuits or maybe the com lines that keep ECM or TCM from communicating?
Top Bottom