After starter replacement no crank

[johnny89345]

I believe my starter went bad the other night chasing an ongoing issue. I was cranking to test injector return rates. On my 2nd 5 second crank, truck stopped cranking and just clicked from the solenoid. I replaced the starter, cleaned all grounds. Now the truck won't crank with the key. But if I leave it on key on and remove the #5 relay it cranks on its own.

 

[2004LB7]

Try disconnecting the batteries first for a minute. See if that resolves it. You might have ran the batteries low and caused the ECM to freak out

 

[johnny89345]

Try disconnecting the batteries first for a minute. See if that resolves it. You might have ran the batteries low and caused the ECM to freak out

I had the batteries hooked to a charger the whole time, if anything i drained them while it cranked . I'll recharge and disconnect them later. This trucks been kicking my ass.

 

[johnny89345]

Try disconnecting the batteries first for a minute. See if that resolves it. You might have ran the batteries low and caused the ECM to freak out

Charged batterys and reset. Not the problem.

 

[2004LB7]

Charged batterys and reset. Not the problem.

Did you actually disconnect them first? Or just charge them up?

 

[johnny89345]

Did you actually disconnect them first? Or just charge them up?

I disconnected and charged overnight

 

[Ron Nielson]

Verify the ING A and CRANK FUSE fuses are good and both are receiving B+ power