I'm a month out before mine will go on.
Well I guess it's time
- Thread starter hondarider552
- Start date
That things a turd Brian, I'll show ya how a truck should run. :rofl:
Video or it didn't happen:roflmao:
:happy2: Mikes in the morning. Yes, im doing the :dancenana:
How did your ats downpipe fit and who did you buy it from?
ats... Post # 52
Paging mike L... Creepin in yo parking lt...
Trans was out, cleaned, built and back in the truck by 3pm I'm always amazed how fast mikes guys can complete an Allison.. Back on the trailer and headed back to Phoenix.:happy2: surviving on NOS energy drinks and Oreos 
Discovered my output shaft seal from the t-case to driveshaft is leaking pretty good, I assume pull driveline, remove seal and install new one? Any tricks of installing?
Run 90w it will quit leaking
Replace tail shaft bushing & possibly slip yoke. They get worn over time. Sometimes a guy will get away with just a seal & others its the bushing in tcase output. Have you drained the oil in the tcase recently? If its silver & flaky you know the deal! Good luck I hope it's only the seal. Retail for around $50.00
Brian, I bet $ he is right about this. I've replace my output seal 3 times still drips. I was also told by Chevyburnout1 (who worked on my truck in person) that its likely the slip yoke.
Call me and I will send you a seal.
Told you to call mike, brian
EDIT: so did steve hahaha
EDIT: so did steve hahaha
Will do Mike
Told you to call mike, brian
EDIT: so did steve hahaha
I know, but his shop was closed when I called you two guys
I know, but his shop was closed when I called you two guys
see below
see above
:hug:
Mine leaked for a while and when I trashed my driveshaft I put a new shaft and yoke in it quit leaking for another yr. So I just started running syn. 90w. When it started leaking again
Huge thanks to James for his help today, installed the new gearbox, centerlink, sleeves, pitman and idler arms in a few hours, took it out for a spin and she launches straight as an arrow. Needs an alignment
Ran to the auto parts store and bought a new tailshaft seal although mike already sent me one. Removed the old seal, installed the new one and only got a few drips so far, I only have about 20 miles it, but for now, it's not dripping. Ill make sure to watch it though :thumb:
Goes in Tuesday for an alignment, then turn the wick up for Friday night. :woott:
Ran to the auto parts store and bought a new tailshaft seal although mike already sent me one. Removed the old seal, installed the new one and only got a few drips so far, I only have about 20 miles it, but for now, it's not dripping. Ill make sure to watch it though :thumb:
Goes in Tuesday for an alignment, then turn the wick up for Friday night. :woott: