Mike,
I sent you a couple of PMs, not sure if you received them or not. But any way's I just had some supports done on my 09 Dmax, Cognito front end supports and a system that pulls a lot juice. After getting my truck back it started throwing a P0708 code, would stay in what ever gear it was in & show service stabiltrak on the dash. I would pull over and clear the code with my autocal then it would drive just fine for a little while and do it again. I googled that code up came a thread you posted to back in 2010, saying it was the NSBU switch. But today I get up, go to the store and when I get back it goes into LIMP MODE, wont move at all, wont go into gear, couldn't pull any codes with autocal. Its a built Gmax 6 with 20k miles on it, never been down the track. I'm completely speechless, confused and more confused. Its not a kit, Suncoast built the trans and sent it to me. Please help
I sent you a couple of PMs, not sure if you received them or not. But any way's I just had some supports done on my 09 Dmax, Cognito front end supports and a system that pulls a lot juice. After getting my truck back it started throwing a P0708 code, would stay in what ever gear it was in & show service stabiltrak on the dash. I would pull over and clear the code with my autocal then it would drive just fine for a little while and do it again. I googled that code up came a thread you posted to back in 2010, saying it was the NSBU switch. But today I get up, go to the store and when I get back it goes into LIMP MODE, wont move at all, wont go into gear, couldn't pull any codes with autocal. Its a built Gmax 6 with 20k miles on it, never been down the track. I'm completely speechless, confused and more confused. Its not a kit, Suncoast built the trans and sent it to me. Please help