I just pulled with my truck Tonite and I'm 99 percent sure the turbo bearings are shot and I have wheel to housing contact. I need to get the truck up and running asap. I don't really have time to research drop in turbos. I have the lds 63.5 kit in my factory turbo and like it. It added 25 hp and 98 tq over the stock wheel with no tune changes. I would love to put on a turbo with some better spool up if possible. Was quick looking at the lds 68mm or stick with a 64. Any advice on my option would be appreciated so I can make a decision sooner than later.
Mods are in my sig and my hp goals at this point do not include a engine build so under 550 hp max.
Side note should I be worried about metal getting in my motor. Does the intercooler usually catch it all or am I just worried too much. Haha I'm hoping there is little to no metal. Hopefully get it all apart this weekend to see.
Mods are in my sig and my hp goals at this point do not include a engine build so under 550 hp max.
Side note should I be worried about metal getting in my motor. Does the intercooler usually catch it all or am I just worried too much. Haha I'm hoping there is little to no metal. Hopefully get it all apart this weekend to see.
