I've got the connectors apart and I'm trying to install the pins. The harness came with one black and one blue wire so I made the assumption the black wire goes to the black connector and blue to blue. The shoulder of the pin on the blue wire is too big to fit into the connector body. It goes up to the shoulder and you can see it is just bigger than the hole in the connector. The black wire fit ok. It is shorter than the original pins but it looks like it will make contact.
I pulled the black wire back out and tried to install the blue with the same results.
Are the pins suppose to be the same. Without removing some of the original pins I can't tell for sure but they look the same (black and blue connectors).
04 LLY/A 4X4 SLT CC SB
EFIlive, ISSPRO Boost/EGT/Fuel Pressure, MBRP Cat-Less, Finger Stick & plate, SD lift pumps, SD manifold, BD Exhaust Brake, TxC CAI, SC IV/cooler/brace by Mike L.
I pulled the black wire back out and tried to install the blue with the same results.
Are the pins suppose to be the same. Without removing some of the original pins I can't tell for sure but they look the same (black and blue connectors).
04 LLY/A 4X4 SLT CC SB
EFIlive, ISSPRO Boost/EGT/Fuel Pressure, MBRP Cat-Less, Finger Stick & plate, SD lift pumps, SD manifold, BD Exhaust Brake, TxC CAI, SC IV/cooler/brace by Mike L.
Last edited: