My 07 LBZ truck is due for ball joints once again. have gotten 100k+out of the moogs this last set. Truck has 315k miles on it and I should probably do the control arm bushings as well. this has me wanting to get the cognito or kryptonite uca's. However I run the factor wheels with 285's and have read that there can be clearance issues with the tire hitting the control arms. With this set up, should I just rebuild the factory control arms or would I be better off with the upgraded uca's. Appreciate everyones thoughts.
Factory vs cognito/kryptonite UCA's?
- Thread starter 07mydmax
- Start date
I'm not an expert in this arena, but I believe the actual arm, depending on model, is very close to being the same between those two. Cognito I think uses Moog ball joints so not much difference between stock. kryptonite supposedly has better ball joints. Also, kryptonite has lifetime warranty. Not sure what cognito has.
I'd pick kryptonite or stock over cognito
I'd pick kryptonite or stock over cognito
If stock is working for you, I would probably stick with it. IIRC when I was running H2's and stock UCA's they were close to touching. Like 1/4 inch close. But it worked.
I think you will rub with aftermarket UCA's. Not only that but when you turn to full lock you might rub the UCA also.
I think you will rub with aftermarket UCA's. Not only that but when you turn to full lock you might rub the UCA also.
I run kryptonite With 285 no issue. My truck never drove as good as it does now
Cognito UCA with 315’s. Had to fender mod but not clearance issue with the control arms. I got the boxed style and they’ve been great, including the provided bolt in ball joints.
I’m on 17” eagle alloys. Forget the backspacing number but it helps for sure. Missed the part that OP is on factory wheels. I would switch those out with the UCA at the same time.
Yes. I have a set of PYO and a set of Mikey Thompson look alike. I run cooper at tires in 285/75/16
Personally I would either run new Moog upper arms (DO NOT rebuild them) and Moog lowers or Kryptonite everything and be done. I personally have Moog on my LB7 as they've done us well at my shop over the years.
When I was running H2's 285/70/17 and Cognito tubular UCA's, my tires would rub the UCA's on full lock left or right. I cant remember if I was at stock height or "leveled" though.