Update:
He got it to read all the way to 91% before it threw the error..
He got it to read all the way to 91% before it threw the error..
If you could flash it, its not the same issue lol..
Sent from my iPhone.
Steve the lly has the boot sector as read only and on a completely different chip.
Basically impossible to brick.
Have him pull the comb out of the comm-bus splice pack, its under the knee bolster kick area. He then needs to pull all the wires except green and purple iirc. That is the datalink connector and ecm. You basically just made a bench harness. Then see if he can flash. That will eliminate all other electronics or modules on the bus as a cause.
use autocal hooked to a laptop with scan and tune. Like moonshine said the software for lly is good.
That works also. And in theory less chance of screw up
Maybe you can use that autocal to tune his buddiez too
U might make out here:thumb:
He has a buddy with an LLY. They are going to put his ECM in that truck and try it from there.
Get ready to direct them to the VATS thread lol... Been there done that![]()
Just send him a tune with vats off
Just send him a tune with vats off