:happy2:
What area is your friend from Michigan from?
It was from me pulling all the tcm pins out to swap to new plastic clip/plugs. I put the second ground on the clear plug in pin #4 instead of #5.
If he never touched the pins, I doubt it’s his issue. I would definitely double check the main ecm/tcm ground on the block, pass side. That one will play havoc
I’m pretty sure you and Jon have met. I don’t remember what part but he’s not far from you. He’s my Chrysler engineer buddy
Maiden voyage went well. No bad noises, 55psi I’d boost, 3600rpm, and all temps stayed nice and low. Oil pressure is definitely higher with the melling pump and 20w 50. Idles at 35psi with the truck hot (190* coolant). Very nice. Tune will need some tweaking but I’m going to wait till the second cp3 is runnin. Haze free at idle with these “hazy smokey oval bowl pistons” :rofl:
Heck, my standard bowl race cast haze a bit under that criteria.Wait till dark stick a flashlight 90° to exhaust stream![]()
Stop buying cheap batteries :rofl:
200 dollar AGM boy!!