03' GMC SoCal stroker

duramaxzak

Wanna be puller!
Nov 22, 2008
2,431
14
38
Minnesota
Figured I would share a new truck I purchased and have been working on. After I parted out my dedicated pull truck I said I was never going to build another Dmax, well here we are a year later....

I was planning on building a mild street truck/puller when I ended running across a deal I couldn't pass up. A one owner, rust free 2003 GMC 2500Hd CCSB.

Truck had the following stuff done when I purchased it, with less than 2k miles on build.

- SoCal stroker short block with billet crank
- SoCal stage 2 heads
- SoCal 6480 cam
- 150% injectors
- Dual CP3's
- Bullseye TCT S472 with WCFAB install kit
- Profab manifolds and pipes
- Built Allison with all billet goodies
- Rear Yukon 38 spline axles and locker
- Front Elocker.

John Kennedy did most the work on it and currently tuned it.

IMG_4803.jpg
-
 

Attachments

  • IMG_4803.jpg
    IMG_4803.jpg
    199.3 KB · Views: 340
Last edited:

duramaxzak

Wanna be puller!
Nov 22, 2008
2,431
14
38
Minnesota
So as always, I can never leave anything alone...

I put a 6" Tuff country lift in with 315/75/16 BFG mud terrains.

IMG_5379.jpg
 

Attachments

  • IMG_5379.jpg
    IMG_5379.jpg
    200.4 KB · Views: 328

duramaxzak

Wanna be puller!
Nov 22, 2008
2,431
14
38
Minnesota
Installing compounds on it, Forced induction ETR S491/96 over the Bullseye S472. I purchased a used WCfab S400/S400 kit from a LBZ, so had do modifie a few things. Will be getting kit re powder coated after fab work is done.

IMG_5278.jpg
 

Attachments

  • IMG_5278.jpg
    IMG_5278.jpg
    182.1 KB · Views: 294

KRODMAX/KS

It'll be alright
Jul 27, 2017
170
21
18
Oz
Congratulations, damn nice set-up and so ready to go!!
I can't lie...I'm a lil jelly:woott: