Search results

Search the forum Search Articles
  1. shakenfake

    WCFab S&B replacement filter

    Does anyone have a part number for an S&B filter that is a replacement filter for the old WCFab intake filter?
  2. shakenfake

    Who makes GM brakes?

    Need to do my brakes on my LBZ. In this category I prefer OE rather than aftermarket. For pads I was planning on going with the "Revised F1 Part Design" that ACDelco offers, 17D784CH1 and 17D785CH1 being front and rear. Does anyone have an opinion on this? However, I believe that Raybestos is...
  3. shakenfake

    Oil pan drain plug crush washer

    What is the part number for the oil pan drain plug crush washer? Last oil change I used Dorkman 65399 and that was definitely wrong and it had too big of a hole and ended up seeping oil. When I got the PPE drain plug it came with a crush washer which I think the P/N for that is 114052002. I...
  4. shakenfake

    Intercooler boot o-ring

    My passenger side intercooler pipe is starting to mark its territory in my shop. Going to pull it and clean it out and I would like to have the intercooler o-rings on hand if I need to replace them as well. Where is everyone getting these? I believe the part number is 19121496. I see a seller...
  5. shakenfake

    Service Brake System message

    Need some help from people more smarter than I, Last year around this time I replaced my batteries after getting a "Service Brake System" message on my DIC. There were a couple of other things that I noticed as well but after the battery replacement the message never came back, and all was well...
  6. shakenfake

    Turbo Rebuild Kit

    Looking for a turbo rebuild kit for when I get around to pulling the turbo, just a stock rebuild kit without any upgrades unless y'all say something is needed (stainless vanes/unison ring help to prevent rust to avoid P2563 and P003A codes?). I can find rebuild kits for the 6.0 PSD, but nothing...
  7. shakenfake

    PPE Up-pipes and manifolds

    I'm building a coffee table and I have a few questions about the up pipes and manifolds, can't find a PPE contact number. If I decide later on to switch to the PPE manifolds as well will the replacement high flow up-pipes bolt right up? I believe the answer is yes but I am just making sure. In...
  8. shakenfake

    P2563 and P003A

    Got a P2563 code and a P003A code with the latter coming intermittently. Working theory is that the solenoid is getting stuck. Trucks oil was changed for the first time in 2 or 3 years last Monday and then 4 days later it went off. Code came back on Sunday and then just went off again today. I...
  9. shakenfake

    New to me '06 LBZ

    Good afternoon everyone! I just purchased about a week ago a 2006 LBZ GMC Sierra that was very very nice on the outside and inside. Test drive and a quick check around the common problem areas told me it was fine and off I went with my purchase. I was recommended this site by someone I know on...
Top Bottom