Recent content by Vmyrhaug

  1. V

    LB7 Y-BRIDGE MODIFIED

    i made my own from steel. and made flow direction change smooth. i thing on high boost, the stock one pushes more are too left side cylinders.
  2. V

    correct converter choice

    how is the 1077 compared to x or g converter?
  3. V

    correct converter choice

    how is the x too drive with compared too g?
  4. V

    correct converter choice

    lb7 2003. planning to build trans in future. (very soon) sac45, light ported heads, ported stock turbo, 3" ybride, ported turbo horn, banks ram air intake. efi live tune, around 400whp(stock trans slipping) 35"tires stock 3,73 ratio looking for converter thight as possible. i want too keep...
  5. V

    precision industries converter

    then i skip this one, would have saved me some money, but too risky...
  6. V

    precision industries converter

    transmission is going too be build, was thinking if this converter i worth the money, or just grab a limitless or goerend in first place..
  7. V

    precision industries converter

    that one my friend is selling is new. 1700stall. my engine is stock, upgraded head gasket, ported heads, arp head studs, light ported head, ported turbo, 3" ybridge, ported turbo horn, ish 400whp with sac 45now. are asking because i save 500 to 700 usd too buy this. are going to build trans...
  8. V

    precision industries converter

    but will be ok in a stock engine/turbo combo? how is theese too drive with, need much rpm to get truck moving? running 35" tires, and stock one need enough rpm to get truck moving.
  9. V

    precision industries converter

    purple tripple disk, 1700rpm stall. only road use here
  10. V

    precision industries converter

    best too stay away then👌
  11. V

    precision industries converter

    are these converter any good? or stay away? have a friend who selling one.
  12. V

    lb7 injector tubes leaking

    then i will ultrasonic clean the old ones. thank for good answer👌
  13. V

    lb7 injector tubes leaking

    its the fuel lines from fuel rail too injector i'm having trouble with. i bought ceap aftermarked ones, and they start too leak on wot, they do not come loose, but loose them up and retorque, they stop leaking for a while. old stock ones is a bit rusty, will they work if i clean then up?
  14. V

    lb7 injector tubes leaking

    so the aftermarked are crap? is it any success too clean and install used one? i have ultra sonic cleaner, and can use acid on them..
  15. V

    lb7 injector tubes leaking

    i have 03 lb7, have changed injectors and injector tubes. have been on road for 3 months now. but, i've had 3 injector tubes that start leaking. and they leak alot. the nut is torqued, when i loose up and retorque, they seal. the if i do a wot run, 1 start to leak again. never the same, but it...
See more
Top Bottom