Xcalliber P2 twisted

Mike L.

Got Sheep?
Staff member
Vendor/Sponsor
Aug 12, 2006
15,444
95
48
Disneyland, CA
On the Excalliber input shafts do you see a lot of slop compared to others? Mines holding up but doesn't fit as tight as the suncoast I ran in the past.
Suncoast is using the TCS shafts from Canada. They fit tight. I quit using them because of this.
 

Mike L.

Got Sheep?
Staff member
Vendor/Sponsor
Aug 12, 2006
15,444
95
48
Disneyland, CA
Yes guys they are warrantying it. Like Evan said, Apparently there was a hardening issue on a batch and I was one of the lucky ones. I guess I better go buy a lottery ticket now :)
So the numbers on the planet matched the problem batch?
 

WolfLMM

Making Chips
Vendor/Sponsor
Nov 21, 2006
3,992
10
38
34
AL
Like Evan said, it was bad heat treating... (I tested under 20rC on the p2 I twisted) pretty sure I was the guy who blew the lid on that situation. Defeo made good on my twisted p2, went way above and beyond. Would buy from them again in a heartbeat.
 

Users Who Are Viewing This Thread (Users: 0, Guests: 1)