LBZ: Rail Pressure Gauge

[Chucky797]

Okay, I was trying to install my rail pressure gauge today and I guess I got a little wild with it. I ended up pulling the two wires that go to the gauge from the sensor out of the harness. Can anyone send me a picture of the harness that goes into the back of a Autometer Cobalt gauge? The wires should be a purple and a black wire. It would be appreciated if someone could do that little task for me.

Thanks

 

[Bikey]

pdf is here, I would think wiring is common for all autometer gauges - http://www.autometer.com/media/manual/2650-1481-00.pdf

 

[Chucky797]

Thanks, I have the instructions I am trying to re-pin the connector that plugs into the back of the gauge.

 

[Chucky797]

Just in case anyone else might need this later on down the road this is what I got when I emailed Autometer about it.

http://www.autometer.com/media/Diesel_Fuel_Rail_Pressure.pdf