New Wagler intake!!!
- Thread starter duramaxzak
- Start date
Anyone install one of these intakes on a LB7 yet? Still wondering what you do about the fuel block and HP lines that run to it!
I will probably get ahold of Wagler next week about one!
I will probably get ahold of Wagler next week about one!
Mine is at the powder coater, I can post some tomorrow if no one else does. There are two drilled and tapped holes on the under side, one is for the air intake temp sensor and the other is 1/8th pipe.
I know this is new but are there any confirmed numbers whether it's cfm and flow or hp numbers that have been proven with this vs a 3" y bridge and runners
Mine has a 3.5 v band inlet. I can tell you there are no restrictions on this, I was supprissd how open it is.
Powder coater had to order more of the red my engine is, intake got spray painted black and will be mounted tomorrow.
Powder coater had to order more of the red my engine is, intake got spray painted black and will be mounted tomorrow.
Last edited:
I have been told they make 150 hp increase.
Sent from my SM-G920V using Tapatalk
I understand there are a lot of variables but was wondering if wagler took a truck with a y bridge compared to this intake for some numbers or proof vs other plenum intakes
As I stated in have been told they did. Contact HSP and he can provide you with more info about it.
Sent from my SM-G920V using Tapatalk
