Well My new motor is finally done, picking it up in a few weeks at Burkette Racing Engines. I cannot say enough good things about jeff. I dropped him off what I though was a block that had been properly machined. Boy was I wrong when I received the call from him saying He had to pretty much redo everything. The build consists of:
.020 over fingers pistons
crower rods
ARP main and head studs
ATI damper
clevite main bearings
comp valve springs
port n polish
everythings keyed
Im probally forgetting some things, I will still be running my s475 bat from Danville. injectors will atleast be 60 overs with dual pumps. Heres a current picture of my setup.
.020 over fingers pistons
crower rods
ARP main and head studs
ATI damper
clevite main bearings
comp valve springs
port n polish
everythings keyed
Im probally forgetting some things, I will still be running my s475 bat from Danville. injectors will atleast be 60 overs with dual pumps. Heres a current picture of my setup.