Got a lly throwing low voltage codes and randomly going into limp. When it limps has all the pressure switch codes. Read something about pin 2 3 4 need 12 volt at idle? Help needed
low voltage to tcm lly
- Thread starter 770JOHNNYW
- Start date
Check ignition switch.
The actual switch that pops out of the column or I think it's called the cylinder? Or the cast aluminum piece it goes into? Excuse my ignorance I have an extra column just never messed with that type thing on these. Thanks mike
The little plastic switch, not the cylinder.
Neither. It goes in under the cylinder.
http://www.amazon.com/ACDelco-D1426...id=1449246462&sr=8-3&keywords=Ignition+switch
Take off the bottom cover and it pops right out.
Sent from my SM-N910V using Tapatalk
Thanks guys that fix that code I believe now on to the next one