Big crank case vents

[x MadMAX DIESEL]

Is there any good spot on factory, or even the billet valve covers to run another set of vents? I have oil pressure problems and believe it is from lack of venting. I have just dhd fittings with 5/8 hose now


Sent from my iPhone using Tapatalk

 

[x MadMAX DIESEL]

They are the AN fitting type. Maybe going with the barb to hose would vent better?


Sent from my iPhone using Tapatalk

 

[moparkxracer]

I'm running billet valve covers, each cover has a -12 fitting welded to the cover. Each hose goes to its own catch can. I did have to baffle the inside of the fittings to keep excessive oil from being thrown through the fittings off the rockers. I don't see any positive pressures.

You should be able to do the same thing I did with the oem valve covers, just put the fittings between the cylinders and check clearances between the fittings and the rockers.

I'm having issues with posting pictures on this site, they all have to be zoomed in and close up, losing interest in this site.

 

[clrussell]

This is how a set of stock covers I have are done.

 

[x MadMAX DIESEL]

This is how a set of stock covers I have are done.

How big of a hole is that? I can't recall what my dhd ones are

 

[clrussell]

How big of a hole is that? I can't recall what my dhd ones are

Probably 1/2"


Sent from my iPotatoe 6 using Tapatalk