3d-printed switch panel mount repair

[TheBac]

Driver's switch panel rear mount on BBT has been broken for god knows how long. Since its back on the road, Im doing long overdue maintenance. For the heck of it, I searched for ways to fix that switch panel, and up pops this:

Source: https://www.youtube.com/watch?v=2LNwSIiqiSI


So I buy the little 3d bits from the Amazon link under that youtube video, and I'll be damned, the things actually worked. Pretty f-ing cool.

 

[darkness]

They make the whole bracket as well. My arm rest is broken, but the switch panel is hanging on still lol.

 

[1FastBrick]

FYI, on my 05, the bezel's front screw hole broke off when I tried to remove the screw. I used super glue to hold it in place and then an epoxy around it to make it more permanent.

I used some tape to make a dam to build up the epoxy. I wish I took a picture of it. It's much stronger.