1/8 mile discussion and time slips post here!

Chevy1925

don't know sh!t about IFS
Staff member
Oct 21, 2009
18,793
1,110
113
Phoenix Az
Well it's no where near as nice or quiet 😂. But really it does feel good to have a legit race vehicle with all the safety stuff. It's much easier to work on too. Nice going to the track and not worrying about getting booted. It's going to be a continuous project with no real goals in mind. Here is a link to the 6.13 pass. It has a ton left in the 60', but got to work my way into it. So much different to get a light weight truck off the line hard.

Source: https://youtu.be/qaJaQuxq1lI

hell yeah! you get that 60 knocked down and 5s will be easy money!
 

SickLL7Crenshaw

Billy The Kid
Mar 10, 2013
1,084
28
48
29
Mexico
New entry for my friends up in MI.

Jordan Pitcher
02 LB7 SCLB 6300lbs
480k miles stock bottom end
Single s400, S&S fueling
UDT ECM/TCM Tuned
 

Attachments

  • D9D8DAD9-0710-4162-8111-B662AF2771F5.jpeg
    D9D8DAD9-0710-4162-8111-B662AF2771F5.jpeg
    167.6 KB · Views: 52

MarkBroviak

DMax Junkie
Vendor/Sponsor
May 25, 2008
1,981
209
63
Danville Indiana
www.danvilleperformance.com
Got a new guy for the list! This is Paul Vasko's RailCar that weights roughly 2600lbs with him in it and 11/14/21 he went [email protected] on his first time to the track with it and his first full 1/8th pass(first try he accidentally left it in burnout mode. It has the old liquid motor from my ProMod that set the allison record last year. It is rocking the Rick D/ProFab custom light weight Stainless Header manifold and pedestal setup. It is an LBZ with Oval Cast pistons with with a 4L80 transmission setup with our PMT 488/96 SS V-band 1.0housing and some spray. It was supposed to go in his Chevelle streetcar but he found this rail for sale and decided to go this route with the project! This was his first time to the track with it to get his feet wet on a 500hp tune in it. I tune it and we are using the dsp5 switch for staging limiter and burnout mode. He let off at the 1/8th and coasted to this time which means it is going to be really fun when we turn it up and run it out the back. This car has a ton of potential in it and he is already ahead of his goals with it so can't wait to see where it goes next season!

Paul Vasko first 1/8th hit in his new Duramax railcar! [email protected] on 500hp tune. - YouTube
Paul Vasko.jpgPaul V. Rail.jpg
 
Last edited:
  • Like
Reactions: SmokeShow

MarkBroviak

DMax Junkie
Vendor/Sponsor
May 25, 2008
1,981
209
63
Danville Indiana
www.danvilleperformance.com
Buddy Callaway (#9 Madmaxx) got a new personal best during the truck wars race he hosted a couple of weeks back. Tried to blow the stock motor up before putting the built one in it but it is still going. If we could get that updated as well. Sorry for they delay James and thank you sir!

1B08EE96-A766-4313-B13B-751F8417BB89.jpeg
 

Chevy1925

don't know sh!t about IFS
Staff member
Oct 21, 2009
18,793
1,110
113
Phoenix Az
Buddy Callaway (#9 Madmaxx) got a new personal best during the truck wars race he hosted a couple of weeks back. Tried to blow the stock motor up before putting the built one in it but it is still going. If we could get that updated as well. Sorry for they delay James and thank you sir!

View attachment 106582

Dont be sorry! ill update now my friend!
 
  • Like
Reactions: MarkBroviak

MarkBroviak

DMax Junkie
Vendor/Sponsor
May 25, 2008
1,981
209
63
Danville Indiana
www.danvilleperformance.com
#18 Randell Dueck got a new personal best this past weekend! Wasn't the 5.9 he was shooting for but very close and impressive for a 2wd truck with a junkyard stock motor in it! Everything else is the same as before. Thanks guys!


Randell Dueck.jpg
 
Last edited:

Chevy1925

don't know sh!t about IFS
Staff member
Oct 21, 2009
18,793
1,110
113
Phoenix Az
Updated!

Also removed II Shop Truck from spot 25. at the new year, it will have been over the time limitof holding the spot with no updates.
 
  • Like
Reactions: MarkBroviak