Search results

Search the forum Search Articles
  1. Jwatsonlml

    2017 L5p

    Just bought this 2017 l5p with close to 41k miles on it about a week and a half ago i’ve put roughly 1300 miles on it since i’ve purchased it and already have a check engine light for p2002 don’t have an actual scanner to pull the details of the code but all i got from my old lmls autocal was...
  2. Jwatsonlml

    HELP

    update- new return set fixed the problem thanks for your help guys have a few other kinks to work out if this thing
  3. Jwatsonlml

    HELP

    okay i’ll see if it changes once the new line set comes in and update the thread i have a piece of vacuum hose and t fitting in case it decides to completely break to get it by
  4. Jwatsonlml

    HELP

    It is re tuned for the cp3 and turbo but i do have a broken injector return fitting on the return line if that would cause any problems which i think it would i’m just waiting on the whole new line to come in
  5. Jwatsonlml

    HELP

    Also don’t know what could be causing this but i can’t give it more than maybe 40% throttle without it sounding like it’s cutting out and misfiring shaking the whole front of the truck and at low speeds can hear some injectors starving a little with some fuel knock then goes right away after...
  6. Jwatsonlml

    HELP

    got it figured out ended up being a lot of air in the system and i mean a lot but does seem to sputter when getring into the throttle while cruising 50-70
  7. Jwatsonlml

    HELP

    exergy sportsman
  8. Jwatsonlml

    HELP

    2013 lml just did a full rebuild with cp3 conversion and a fleece cheetah truck fires up sounds great then dies like it’s not getting anymore fuel after about 4 seconds no codes or anything at all no kinks in the cp3 rubber lines either completely lost at this point been without a truck for 3...
  9. Jwatsonlml

    2013 lml no crank/no start after pulling trans

    i don’t know where i could get one to pull the codes don’t know anyone with one main trans plug is fine too
  10. Jwatsonlml

    2013 lml no crank/no start after pulling trans

    Just got done replacing all 8 sets of rod bearings had the trans out to get the upper pan off plus both valve covers off on the passenger bank and injectors out obviously but i have no speedo reading no trans temp exhaust fluid level is “—“ truck is deleted so should read ok edge and ez lynk...
Top Bottom