Search results

Search the forum Search Articles
  1. T

    Not getting power to rear passenger window

    I’ll test power at the circuit breaker next and see what I got there. Hopefully it’s 12-14v and if that’s the case I should be able to just run a new positive wire back to the door jam correct? Good news though, I found two more broken wires while tracing the harness and repaired them so now my...
  2. T

    Not getting power to rear passenger window

    here’s the readings I got. Power voltage was pretty strange on the passenger side. It started around 6.5 and would slowly drop and continue to drop. I shut the truck off, turned it back on and tested again and got the same results. I also checked the ground in the pillar and they are good. So I...
  3. T

    Not getting power to rear passenger window

    Actually door locks do work now. The lever was just jammed a little so It wasnt moving enough to engage.
  4. T

    Not getting power to rear passenger window

    Okay so was searching in the door jam for broken wires then I pulled the b pillar off to get a better look at the plug. I found a mouse nest and all the wires were chewed through. So I spliced them all back together but still no power to the window or the locks. So I traced the harness across to...
  5. T

    Not getting power to rear passenger window

    Also, I just realized the power lock doesn’t work on that door either. Don’t know why I haven’t checked that before but I’m assuming that’s definitely related
  6. T

    Not getting power to rear passenger window

    I just got the truck back gone so I’ll have to wait till tomorrow to dig into it. I will have to check in the door jam for broken wires. Also I don’t know if this could be related but my passenger side power mirror does not work at all, and I have 2 air bag codes(b0017 and b0018) both are...
  7. T

    Not getting power to rear passenger window

    Thanks, that’s kinda what I thought but just wanted to verify. I’ll do that tomorrow and let you know what I find
  8. T

    Not getting power to rear passenger window

    Thanks again for the quick responses. I’m not very familiar with tracing down wiring issues. What exactly would I be doing with the multimeter on the back of the switch. I usually don’t dig much into electrical problems in cars so I’m a little lost here
  9. T

    Not getting power to rear passenger window

    The window wouldn’t go up or down. I found that out because the new regulator was partially down when I installed. I will have to wait to do anymore testing because I just dropped it off for inspection.
  10. T

    Not getting power to rear passenger window

    I swapped them and no luck. Also I hooked the passenger side one on the driver side and the switch does work so both switches are good
  11. T

    Not getting power to rear passenger window

    Thanks for the reply I will swap the switch with the rear driver side and see if that works then.
  12. T

    Not getting power to rear passenger window

    No I tested the rear driver side and got 12v. I guess I should test the master switch and see if if it gets power to it then.
  13. T

    Not getting power to rear passenger window

    I just picked up a 2007 Silverado Classic crew cab long bed. While driving home I noticed the rear passenger window wouldn't go down, all other windows work fine. I assumed it was the regulator so I replaced that and still nothing. Neither the master switch on the drivers door or the switch on...
  14. T

    LB7 power steering fluid leak

    so I cleaned everything up and then let it idle for a bit, didn't see anything so a few hours later I checked on it and it looks like its leaking from the pump itself. Cant tell exactly where its coming from but I don't think its either of the lines.
  15. T

    LB7 power steering fluid leak

    Alright thanks a lot. I’ll probably change them out this weekend and see how it works out
  16. T

    LB7 power steering fluid leak

    would those leak while the truck is not running? it isn't leaking a whole lot which makes it hard to tell where its coming from since it took a few days for me to notice a spot under the truck
  17. T

    LB7 power steering fluid leak

    About two months ago I topped off the power steering fluid and its now low enough where it doesn't show up on the dip stick so I know its a ps fluid leak I could use some help diagnosing the leak. I degreased and hosed everything off the best could. Then I started the truck and let it idle and...
    • tkerb92
    • Thread
    • Replies: 7
    • Forum: LB7
  18. T

    01 3500 security light issue

    In case anyone is still wondering how I made out... I took the truck in for inspection to a diesel performance shop and has them try to figure it out. They said the cluster wasn’t connecting to the ecm and wasn’t reading a vin at all. They recommended I take it to a speedometer shop so I...
  19. T

    01 3500 security light issue

    No, nothing like that. The light just stays on while driving and everything else works perfectly. I had to drop my truck off for inspection so I figured I’d let the shop handle it from here. I will post the outcome though
  20. T

    01 3500 security light issue

    So I got a little busy the past few days so just had time to put the batteries on the load tester. I got 13 volts and dropped to 11 under load for both batteries. So I’m I don’t think the batteries are the problem.
Top Bottom