Search results

Search the forum Search Articles
  1. LbzDMax07

    LBZ Coolant leak

    How common is external coolant leak at the head/block? Over a week period of the truck sitting I get about a 6" puddle under oil filter area. I can see coolant on the back of head along the block.
  2. LbzDMax07

    ATS dual fuel kit fitting

    Anyone with a ats dual fuel kit know where this fitting goes? Instructions dont say anything about it. Looks like maybe the high pressure fitting for cp3?
  3. LbzDMax07

    Torque steer with braces and sleeves

    When i launch my truck i get torque steer i believe. Truck pulls left then right. I have a dhd brace, sleeves and no t bar bolts. Only running 265s and Looking at a pic from drag races i have a bit of toe in also. Checked all steering tonight and its good. Not sure what else to check, thinking...
  4. LbzDMax07

    97 silverado problems

    Been fighting issues with my brothers 1997 silverado. Has a 383 stroker and just had the 4l60e rebuilt. We are fighting a p0340 code and now a code for front knock sensor. Knock sensor at starter was replaced along with the distributor a few months ago. Went to set timing with a snap on solus...
  5. LbzDMax07

    Mike L shift/trim valve spring HELP

    Installing his new springs, have the white springs figured out but need to know where the 2 little springs go
  6. LbzDMax07

    u0101 after TCm tune

    Got a tcm tune from Kory. Didnt know any better and full flashed it instead of cal flash. Now getting code u0101. Did i screw my TCM or any ideas what i should do before i call the dealer?
  7. LbzDMax07

    What's this plug?

    Anybody know what sensor is to the left of the fuel rail. This is drivers side. I managed to pull the wires out of the plug
  8. LbzDMax07

    Turbo coolant line after vvt removal

    Installing my hsp s400 kit. I have the oil lines figured out but what about the coolant line. Kit came with a large plug for the coolant crossover i think its called. What about the return part of it? Should i have a plug for it or what?
  9. LbzDMax07

    S400 Oil feed location

    Where does the oil feed come from for a s400 single on a LBZ. I read the factory feed is plugged so where does the new feed come from?
  10. LbzDMax07

    s472/87 with SC 1056

    Gonna be switching to a s472. Convertor in my truck is a suncoast 1056 and was looking to get a s472/87/.9 but not sure if my convertor would be to tight. If its going to be a issue i will go with a s472/83/.9 race cover. Anybody ever ran a setup like i mentioned or have some advise if it would...
  11. LbzDMax07

    Pulled wires loose

    I was adjusting stuff in my truck and pulled 3 wires loose from my lockup box harness. If you have a newer lockup box from ben could someone check the pin locations for me. I pulled the solid black, white and dark pink/red wires loose
  12. LbzDMax07

    What kind of fuel line

    Im in the middle of changing my cp3. I have the new one in but was looking over the short rubber fuel lines and see they are in rough shape. One comes from the test port line and the other comes directly off the top of the cp3 to a hard line that T's off. Im thinking i can use regular fuel line...
  13. LbzDMax07

    How quick can a cp3 die...

    How fast could a cp3 drop from holding 22,000 rail to 16,000 of rail pressure? Last trip to the strip in Sept i held 22,000 when i logged today it threw the p0087 and was only holding 16000 on tune 4. I might have put 2000 miles on it since Sept, seems like it went down hill quick...
  14. LbzDMax07

    Bt Lock up box??

    Im having some issues with a lock up box installation. I installed per instructions but when i turn the key to the run position the LED doesn't light up at all. I have power to the box itself through the A4 pin on the light blue bcm plug. I sent Ben a email but figured id ask here also. What...
Top Bottom