Search results

Search the forum Search Articles
  1. ryanvanl

    suncoast 1055 converter

    It will hold up to 4000 rpm then rap out to 4500 with ease! It locks up good but won't hold it Sent from my XT907 using Tapatalk
  2. ryanvanl

    suncoast 1055 converter

    Sweet! Thank you guys for the input! Sounds like im going to run a 1055 instead of my POS bd that won't hold. Sent from my XT907 using Tapatalk
  3. ryanvanl

    suncoast 1055 converter

    I have a built lb7 with a s366 pushing 700 horse at the wheels right now but it seems to be blowing straight through my bd converter so im looking to upgrade. I have the money set aside to add a s480 or s483 ontop of my s366 this winter. I was hoping to be around 1000 horse with the turbo set up...
  4. ryanvanl

    u2106 help please!!!!!

    yes the fuses are good. I took a test light to EVERY one and they all lit up on both sides. will a bad resistor on the heater cause my truck not to start and drive though?
  5. ryanvanl

    u2106 help please!!!!!

    of coarse the cables are tight and clean. so I probed pin 31 of the red connector which is a 12v reference wire that runs down to the big transmission plug and supplys power to all the shift solenoids and got nothing. I jumped 12v straight to the pin 31 wire and everything works just fine. it...
  6. ryanvanl

    u2106 help please!!!!!

    anyone have any ideas. it was working fine this morning (started up and ran just fine) until i turned on my fan (hvac) while i was driving and then all hell went down. no more dash under gears again. abs light on. park break on. dash says "service 4wd". turned the truck off and tried to start...
  7. ryanvanl

    6.5 to lb7

    I have a fully built lb7 and tranny and i'm thinking about putting it into a 92 6.5. i'm thinking of getting a stand alone harness for both the engine and also a stand alone for the allison. will it bolt in or is there ALOT of mods i need to do?
  8. ryanvanl

    u2106 help please!!!!!

    got a 03 here that wont turn over! I can jump power to crank fuse and get it started that way but not with the key. there is NO dash under the PRNDL with check engine, ABS and parking break (parking break is NOT on) lights on. read codes using my edge insight and found P0380 (been there forever...
  9. ryanvanl

    Allison 5sp: No talky to TCM help!!

    DieselDummy, did you ever figure this out? I'm having the exact same problem. I can start it by jumping power to crank fuse and it goes straight to limp mode. No dash under PRNDL. Harness is fine, ALL fuses are fine and such.
  10. ryanvanl

    Duramax Avalanche

    did u have to do anything to get the allison under it? somewhere i was reading that the allison is taller and would hit the body.
  11. ryanvanl

    Highest Stock CP3 HP?

    I'm running a LBZ pump in my lb7 with 50% over injectors and last time I was in a NON-loaded dyno I pushed 672 to the rear wheels. So I believe its pushing more like 700+ on loaded dyno.
  12. ryanvanl

    hey, i was reading a post from last year about returning a lifted d-max to stock and you said u...

    hey, i was reading a post from last year about returning a lifted d-max to stock and you said u still had your stock spindles and i was wondering if you still have them or not?
Top Bottom