Recent content by dirtydmax

  1. dirtydmax

    Lmm transfer case

    Thanks Malibu,It looks like it will bolt up but not sure on electronics but I'm sure it's been done.This lmm is a whole new animal and miss the 7
  2. dirtydmax

    Lmm transfer case

    Good day gentleman, I'm not quite sure if this is the right section and apologize if not.Im looking for a little info on tc in my lmm,I have always been a 7 guy so it'd been a learning curve but I'm curious what other year transfer case will work on my lmm or an I stuck with 07.5-10?The mp 1626...
  3. dirtydmax

    Lb7 idle surge in park

    Have you done a return rate test on injectors?Could possibly be returning too much as balance rates are only half of the equation
  4. dirtydmax

    Lb7 idle surge in park

    What's your rail pressure in park at idle?
  5. dirtydmax

    Wrecked LBZ Frame Swap

    I like the way you think,Welcome and can't wait to see some builds
  6. dirtydmax

    Allison 1000 5 speed rebuild

    There's nothing better than building your first trans and can be done.I did my first one on a budget with a rgpz drop in kit,pump mod's with converter,That trans held for years with triples I abused the hell out of it.Get your self an atsg manual and study tf out of it before you dig in also...
  7. dirtydmax

    LB7 with 40 engine codes

    I'm curious if rail pressure is spiked
  8. dirtydmax

    LB7 with 40 engine codes

    Just out of curiosity did you check for blow by?Any chance you have pushed in pins in bail connectors?Strange symptoms for sure
  9. dirtydmax

    LB7 with 40 engine codes

    They couldn't figure it out in 6 months?Did you use genuine Bosch remains or a set from a less reputable vendor?
  10. dirtydmax

    LB7 with 40 engine codes

    Check wiring harness under drivers wheel well coming out of ecm for rub through.
  11. dirtydmax

    LB7 with 40 engine codes

    Mine ran,fired right up as well but white smoke/ raw fuel and and ran like shit as well once i started driving.We're you into valve train at all?
  12. dirtydmax

    LB7 with 40 engine codes

    Any change with for unplugged?Check fpr pigtail
  13. dirtydmax

    LB7 with 40 engine codes

    I have had something similar when I was 180 out,this possible?
  14. dirtydmax

    LB7 with 40 engine codes

    If batteries were hooked up when bail connectors were separated to do injector job that's most likely where your codes came from.Truck's still running rough blowing smoke is prob a hard part failure but clear coded and re check.Ballance rates?
  15. dirtydmax

    LB7 with 40 engine codes

    Clear codes and re check,possible bail connector issue with all that going on