DAVe3283's latest activity
-
Episode #1234 Not long after getting the LML I ordered a fleece powerflo in tank lift pump and exergy metering valve. I thought it was... -
That second pic, I was exploring those options.. However not sure how much I would trust the printed part being our mounting point.. I...
-
just so you guys don't fall asleep. Board #2 has been made and we're just waiting on shipping. then we can load up the latest code and...
-
Get it in before the thread closes '82 on the year
-
Burb with a dually rear???? Do it, do it....😛
-
I threw a tire on to see what it looked like and didn’t get a pic. The pic above is at full bump. Tire slightly rubs the radius arm at...
-
DAVe3283 replied to the thread Got Sludge?.Blackstone still recommends 10k+ miles changes on my Duraburb, but they dropped the recommendation from 5k to 4k on my blue truck this...
-
Ok,, so far for this T14 is a happy camper with 4 of these bigass hot plate resistors and 4 stock solenoids. I also put some little 12v...
-
DAVe3283 replied to the thread New member, long time lurker.If you're not touching the block or bottom end of the motor, you don't need to measure piston protrusion. You can just order the same...
-
I know this is old but after having a customer push a stock motor to 1460hp calculated by track time vs weight I will say that is...
-
DAVe3283 reacted to MarkBroviak's post in the thread Paul Vasko's new Dmax RailCar makes its Debut Technical info Thread! with
Like.
Ok, so lets dig into the data for 4.06 pass because it is interesting to say the least. The car was on the brake at 4550rpms and was... -
Sticker says it all.. [emoji3] Sent from my SM-S901U using Tapatalk
-
DAVe3283 replied to the thread LBZ Fan Clutch.Indeed, the LBZ fans are stupid sharp on the mold/flashing lines. What I found is a deburring tool makes quick work of it, much...