Bdsankey's latest activity
-
Haha. Damn auto correct strikes again. -
Bdsankey replied to the thread Aluminum Radiators?.Please excuse the ignorance, ATV sealant?
-
I've heard it a couple times from dealer techs, they always crimp the tanks tighter on a new rad before install. Not sure if it's good...
-
Radiator with leaking tank at seam Pry with screwdriver to open the little tabs After screwdriver, you can carefully open them a...
-
Bdsankey replied to the thread -8AN CP3 Pump Fittings.Should be golden then! Mine was purely the balance line giving me issues on the LB7 platform. Now that I'm changing that I shouldn't...
-
Kodiak is an lly. I’ve got nothing in the way back there to come straight up. Van thermostat housing, soft return lines from replacing...
-
Bdsankey replied to the thread -8AN CP3 Pump Fittings.Depending on the generation of truck I've seen it hit the balance/crossover line, at least that was the condition on my LB7 when trying...
-
Bdsankey replied to the thread Bad converter or something else? No DTC's.It is incredibly wise to replace them or at minimum have them professinally hot flushed. For example, I will instantly void the...
-
OK, got the measurements I wanted, and hopefully the measurements y'all wanted too! I have been running stock Hummer H2 rims with...
-
Bdsankey replied to the thread Allison 10L1000 10 speed valve body fixes.This is great feedback!
-
Bdsankey reacted to Chevy1925's post in the thread Allison 10L1000 10 speed valve body fixes with
Like.
The high and low limit feed valve fix from sonnex still seems to be top dog imho. Got a guy with 50k on it since we did the fix (hot... -
Bdsankey replied to the thread First Diesel - Frame Off and Full Built LBZ.You did not need a built engine/bottom end to run 100% injectors, 10mm CP3, and a drop-in VGT but it also doesn't hurt. The dowels are...
-
Bdsankey replied to the thread 06 tap shifter in <05 truck.Bingo
-
My set shows up this weekend. As far as I can tell the size and offset is identical to the GM factory Hummer H2 rims which work great...
-
Most likely tried torching it to bring the color out to like new. It's very short lived if you do that and makes it much more brittle...