Recent content by 02 DMax

  1. 0

    Rail pressure guage

    Rail Pressure gauge? Are these ready for 02 lb7 motor?
  2. 0

    Intercooler?

    Will a lly intercooler fit onto my 02 lb7?
  3. 0

    Dead Pedal

    On my 01 dmax i keep getting dead pedal syndrome saturday going down interstate it happen 5 times, check for codes and nothing stored. Any ideas? truck has 180,000 miles on it.
  4. 0

    Rail pressure guage

    02 lb7 Just checking to see if the rail pressure gauge is ready yet for 02 lb7 from ppe?
  5. 0

    Rail pressure guage

    Rail Pressure Gauge Any idea when these will be ready for lb7?
  6. 0

    LB7 Low Fuel Rail Pressure

    Rail Pressure Got hooked up to tech II and rail pressure is good to go.
  7. 0

    Rail pressure guage

    Rail Pressure Gauge Are these available for the Lb7 yet?
  8. 0

    LB7 Low Fuel Rail Pressure

    Low Power? Yes i am positive the fpr was sticking and now when i unplug the fpr it idles like it has a big cam and plug it back in it quiets down and it has some power again, friday i am going to get hooked up to tech II and make sure everything is up to snuff. I will report back. Thanks again...
  9. 0

    LB7 Low Fuel Rail Pressure

    Rail Pressure Well i hooked up vacuum gauge to test port and that reads normal then i unplugged the fpr and it souded alittle noisy than normal so i hoooked it back up drove it about 100 miles this past weekend and popped the plug on the fpr again and now it idles like it has a big cam with the...
  10. 0

    LB7 Low Fuel Rail Pressure

    Fuel pressure Thats what i needed to know, yes it sounded like high timing with the fpr unpluged. So there is no sense in removing that? I will get hooked up to tech II and see what that says and hollar back. I will hook up vacuum gauge to test port and check that again also.
  11. 0

    LB7 Low Fuel Rail Pressure

    Low Power? I put tank back in tonight and left shop and truck run great instant boost and that lasted short time and back to old turd again. So i went back and unplugged fpr and it took a few seconds then it sounded like timing was advanced while idleing. Should it still idle smooth with fpr...
  12. 0

    LB7 Low Fuel Rail Pressure

    Low Rail Pressure? Ok guys i had a brain fart, while watching my rail pressure the desired pressure would only go up to 9800psi on the 120hp setting on my ppe hot +2 and the actual was 1600 psi. I think i have a electrical problem. I am going to remove chip and install on my 01 and check rail...
  13. 0

    LB7 Low Fuel Rail Pressure

    Low Rail Pressure? Thanks for the info!!! i am going to reinstall the fuel tank tonight and try unplug the fpr and maybe i will just pull the fpr and is there anyway to check to see if it is stuck?
  14. 0

    LB7 Low Fuel Rail Pressure

    Low Rail Pressure? Where is the relief valve on the junction block located on my lb7? I have had two people tell me shim this up by adding two more shims and put it back together.
  15. 0

    LB7 Low Fuel Rail Pressure

    Rail Pressure What would happen if i unplug the fpr electrical connector and start the truck, i should hear different tone from the motor? Maybe or is this a bad idea?
See more
Top Bottom