Search results

Search the forum Search Articles
  1. 0

    Rail pressure guage

    Rail Pressure gauge? Are these ready for 02 lb7 motor?
  2. 0

    Intercooler?

    Will a lly intercooler fit onto my 02 lb7?
  3. 0

    Dead Pedal

    On my 01 dmax i keep getting dead pedal syndrome saturday going down interstate it happen 5 times, check for codes and nothing stored. Any ideas? truck has 180,000 miles on it.
  4. 0

    Rail pressure guage

    02 lb7 Just checking to see if the rail pressure gauge is ready yet for 02 lb7 from ppe?
  5. 0

    Rail pressure guage

    Rail Pressure Gauge Any idea when these will be ready for lb7?
  6. 0

    LB7 Low Fuel Rail Pressure

    Rail Pressure Got hooked up to tech II and rail pressure is good to go.
  7. 0

    Rail pressure guage

    Rail Pressure Gauge Are these available for the Lb7 yet?
  8. 0

    LB7 Low Fuel Rail Pressure

    Low Power? Yes i am positive the fpr was sticking and now when i unplug the fpr it idles like it has a big cam and plug it back in it quiets down and it has some power again, friday i am going to get hooked up to tech II and make sure everything is up to snuff. I will report back. Thanks again...
  9. 0

    LB7 Low Fuel Rail Pressure

    Rail Pressure Well i hooked up vacuum gauge to test port and that reads normal then i unplugged the fpr and it souded alittle noisy than normal so i hoooked it back up drove it about 100 miles this past weekend and popped the plug on the fpr again and now it idles like it has a big cam with the...
  10. 0

    LB7 Low Fuel Rail Pressure

    Fuel pressure Thats what i needed to know, yes it sounded like high timing with the fpr unpluged. So there is no sense in removing that? I will get hooked up to tech II and see what that says and hollar back. I will hook up vacuum gauge to test port and check that again also.
  11. 0

    LB7 Low Fuel Rail Pressure

    Low Power? I put tank back in tonight and left shop and truck run great instant boost and that lasted short time and back to old turd again. So i went back and unplugged fpr and it took a few seconds then it sounded like timing was advanced while idleing. Should it still idle smooth with fpr...
  12. 0

    LB7 Low Fuel Rail Pressure

    Low Rail Pressure? Ok guys i had a brain fart, while watching my rail pressure the desired pressure would only go up to 9800psi on the 120hp setting on my ppe hot +2 and the actual was 1600 psi. I think i have a electrical problem. I am going to remove chip and install on my 01 and check rail...
  13. 0

    LB7 Low Fuel Rail Pressure

    Low Rail Pressure? Thanks for the info!!! i am going to reinstall the fuel tank tonight and try unplug the fpr and maybe i will just pull the fpr and is there anyway to check to see if it is stuck?
  14. 0

    LB7 Low Fuel Rail Pressure

    Low Rail Pressure? Where is the relief valve on the junction block located on my lb7? I have had two people tell me shim this up by adding two more shims and put it back together.
  15. 0

    LB7 Low Fuel Rail Pressure

    Rail Pressure What would happen if i unplug the fpr electrical connector and start the truck, i should hear different tone from the motor? Maybe or is this a bad idea?
  16. 0

    LB7 Low Fuel Rail Pressure

    Low Rail Pressure? I installed the cp3 myself. Can the fpr be removed without pullin the entire cp3 back out? I bought a new Lb7 regulator and had that modded.
  17. 0

    LB7 Low Fuel Rail Pressure

    I need some help on my 02 LB7 I just had new injectors installed and new fuel filter and new LBZ CP3 with modded fpr and my rail pressure is 9800 psi and drops to 600 psi when going to wot? I dropped out fuel tank tonight to see if pickup screen was blocked and it was clean. Truck is very slow...
Top Bottom