Just got my new lockup controller from Ben, working on installation.
I am wondering if I received the correct harness for this box.
First, there's a green wire and an orange wire in the gray harness that goes to the TCM controller, both are terminated with female PCM pins. There is no mention of these wires in the instructions I downloaded from Ben's site. Second, the instructions mention a pink power wire and a black/white stripe ground wire that come from the lockup box. The harness I received does not have either of these.
Did I receive the wrong harness for this box? Are there revised instructions that I should be following instead?
Pic of the harness:
Also, the instructions mention that I should have a sticker on the box that has software info and a 5/6 code to designate if it's a 5 speed or 6 speed box. The box I received doesn't have a sticker. Was it supposed to, or has there been a change?
I am wondering if I received the correct harness for this box.
First, there's a green wire and an orange wire in the gray harness that goes to the TCM controller, both are terminated with female PCM pins. There is no mention of these wires in the instructions I downloaded from Ben's site. Second, the instructions mention a pink power wire and a black/white stripe ground wire that come from the lockup box. The harness I received does not have either of these.
Did I receive the wrong harness for this box? Are there revised instructions that I should be following instead?
Pic of the harness:
Also, the instructions mention that I should have a sticker on the box that has software info and a 5/6 code to designate if it's a 5 speed or 6 speed box. The box I received doesn't have a sticker. Was it supposed to, or has there been a change?