Search results

Search the forum Search Articles
  1. bradyn

    my twist on a aux oil cooler

    Looks good.
  2. bradyn

    Help: Lower Ball Joint

    Torch. Blow the center out.
  3. bradyn

    Most awesome DIY engine stand ever

    That is incredible!
  4. bradyn

    New Lube Setup.

    ^^^ The Maxitron in your sig is incredible!! Lol:thumb:
  5. bradyn

    lbz vanes stuck between 76.7% 80.1%

    Mine was stuck at 0% a couple of weeks ago. I did the same as you, except where the sensor screws in I took a screwdriver and did a little wiggling. It got unstuck and has been fine since.
  6. bradyn

    LLY/LBZ Mouthpiece with Twins Over Stock Turbo

    Call up wcfab in Illinois. I know for a fact the stock and aftermarket mouthpieces will leak. Also I think empire diesel sells just the flange but its like $60 bucks.
  7. bradyn

    wanna make 650-700hp

    Isn't it common knowledge that stock head bolts are good for 60 psi? I ran 60 psi for darn near a year and had zero issues with my heads lifting.
  8. bradyn

    LBZ: what need to install s475

    Wcfab will sell you any piece you need made up. When I built mine Jason was the only guy that built kits that would help me out. Not trying to start a riot, just trying to help ya out.
  9. bradyn

    Help: Timing calculator

    http://www.dieselplace.com/forum/showthread.php?t=187521
  10. bradyn

    Rule discussion for new stock truck list

    Sounds good except by body panels not being removed. Is the tail gate an acceptable removal? Manifolds and up pipes are they allowed to :roflmao:be upgraded? Or an lml manifold swap? That's all I can think of.
  11. bradyn

    LBZ: Just got EFI live, help, turn off egr

    Plug your controller into your truck and your laptop. Then open efilive into your window. You will have to go through all of the registration. You should have got a card that will have all the info. Once that is complete you'll see on the top of the screen an arrow that when scrolled across...
  12. bradyn

    New Noise??

    Could it be an up pipe or manifold leaking? Do you see any soot around where you hear the noise from?
  13. bradyn

    Trans whining

    From what I've read its the pump making the noise and is completely normal..just annoying.
  14. bradyn

    Ball joints?

    I put a set of ball joints in at 15000, they lasted a year, they were orielys house brand masterpro. They didn't just wear out like a typical ball joint would. The drivers side lower snapped in half leaving work. It was warrantied so I replaced it with a moog. Then one week later the other side...
  15. bradyn

    EGTs with S475/stock twin turbo setup

    With my old home made kit I wouldn't ever go over 1400* that was about 57 psi.
  16. bradyn

    Hey I sent you a message on diesel place about that regulator idk if it went through or not for...

    Hey I sent you a message on diesel place about that regulator idk if it went through or not for some reason I can't post over there. Would you take $100 shipped? If so what's your paypal?
    • bradyn
    • Profile post
  17. bradyn

    Non Duramax electrical gremlin

    Might just be a bad ignition switch. Or a bad starter relay, when its hot swap a different relay and see what it does.
  18. bradyn

    Allison 5sp: How to make a high HP allison live???

    Ok thanks!:thumb:
  19. bradyn

    LLY: Few pics of my truck

    Awesome rig!:thumb:
  20. bradyn

    Allison 5sp: How to make a high HP allison live???

    Mike would you want to sell me a longer spring or is it something I can pick up.from the hardware store or online?
Top Bottom