Search results

Search the forum Search Articles
  1. 19trax95

    Lift pump draw straw length

    I wouldn't just install the draw straw without at least verifying it is the correct length. They need to be trimmed to length as it is, so there isn't anything to say it was cut too short to begin with.
  2. 19trax95

    Testing LML VPS to ECM

    I'm helping my buddy out with his 2012 that he's having some issues with. The turbo is seemingly stuck with the vanes open. Scan tool data shows the commanded vane position is 95% at idle but the actual vane position sits around 2% no matter what. I can command the vanes to move, and the ecm...
  3. 19trax95

    Help on tires

    The toyo open country AT is my favorite tire by far. I've tried other tires and have always been fairly disappointed. I had a set of Cooper AT3 xlts on my 17 and they were by far the worst tire I've ever had in the snow. Last winter I had a set of bfg ko2s and they did good in the snow, but...
  4. 19trax95

    LML Turbo suggestions needed.

    Yeah likely nailed the turbo manufacturer on the head lol. Really blows. Maybe had 6k miles on it. So with say an S480 over stock, 10mm cp3 (or would a 12mm be better?), 100% over injectors and then good, mild tuning, that would be a fairly sweet setup? I really should have clarified my...
  5. 19trax95

    LML Turbo suggestions needed.

    Mike L built trans, Goerend R converter. With the 66 in the valley, and an s480 over top, would it spool similar to how it is with just the 66 or would it slow down a bit until the big charger takes off? I know that the different exhaust housings on the s480 would also change things as well...
  6. 19trax95

    LML Turbo suggestions needed.

    Ok so I'll try and bypass the longer part of this story. So the short of it is, I currently have a sportsman cp3, stock injectors, built trans (rated to 750hp), 66mm VGT, high flow intake/exhaust piping, and a fass 165. The 66mm turbo blew the shaft apart, so the turbo needs to come out to...
  7. 19trax95

    Cold air intake ?

    I assume it was an oiled filter? If so, it's possible it was over oiled and the oil covered the maf sensor. They are fairly sensitive to debris, especially oil, coating them.
Top Bottom