Search results

Search the forum Search Articles
  1. straightpiperoar

    Diesel Drag race at Rogersville mo

    just letting everyone know that ozark dragway is having a Blackout Race day this saturday...Gates open at 2....Diesel only!!!!!! Info Found here: http://www.ozarkracewaypark.com/
  2. straightpiperoar

    Strange Tune problem HELP!!!

    Long story short....I got a built motor tune at the first of the year and loaded it into my truck....Seemed to run ok but was having some tranny problems so I got a tune that was on the mild side to be able to run until I got the tranny figured out....The truck ran so good on the mild tune that...
  3. straightpiperoar

    Diesel Drag Race in Tulsa OK

    http://www.tulsaracewaypark.com/schedule/event/25-diesel-power-plus-diesel-drags-mods-vs-rods-gates-9am-qual-10am Just wanted to let everyone know what was going on...It was a great event last year.....
  4. straightpiperoar

    Rear engine water leak

    Went to gateway in st louis this friday night and after the first run I noticed after paking it to let it cool down it was leaking water....Searched and found that it is coming from the pass side and running down along where the rear engine plate mounts to the block.. I dont think it is coming...
  5. straightpiperoar

    Spearco blowout

    Was running the truck at the TS event on friday and heard a pop mid run...Noticed i lost all boost and figured it was a boot....Got it in the shop and NOPE lost the cooler...Is this something they will stand behind sinced the weld itself cracked????
  6. straightpiperoar

    LBZ truck to LMM

    If I have a complete LMM motor and trans with ecm and tcm...what problems will I have with swapping this into a truck that had an LBZ in it...Will the guages and everything work if we just swap them out...thanks mike
  7. straightpiperoar

    G2G This winter

    Anybody got any ideas on getting together in jan or feb..Last winter i think we went to the SDX shop in Arkansas...Any ideas....
  8. straightpiperoar

    One balance rate is off the charts help!!!

    I have 100 over injectors which had 35,000 on them when I did different nozzels and was breaking in a new motor....Hadnt drove it more that 5 miles when it started to run rough..Checked the balance rates with EFI and this is what I got. #1 12.17 #2 -4.02 #3 -4.02 #4 2.17 #5...
  9. straightpiperoar

    injector re-assembly

    I had the #1 injector stuck open so I took it apart and cleaned it...I was watching very close to see the order that the parts came out...In the injector body there was a spring and a spacer that I dont know what order they go back in....spacer then spring or spring then spacer....Thanks for the...
  10. straightpiperoar

    Wastegate gasket

    Is there a gasket that i should use at the connections between the wastegate and the hotpipe or do most of you just use the v-band clamp????? I cant seem to get mine to seal completely
  11. straightpiperoar

    Whats to much oil pressure???

    At what level of oil presssure does a person need to be worried about hurting the seals in a turbo?????
  12. straightpiperoar

    Break In Oil or just the regular

    Just about ready to try and start a motor that has just been built....Does anyone use break in oil....to start with or does everyone just use regular 15-40.....thanks mike
  13. straightpiperoar

    Flexible line that can handle the pressure

    Is there a flexible line that can be used to run from the cp3 to the fuel rail????or has anyone tried anything other than the hard line...
  14. straightpiperoar

    Percent Over Vs LPM

    Can someone help me out...Lets say you have 100% over injectors what is that LPM....Or can you even figure that out unless they are flow tested...thanks mike
  15. straightpiperoar

    Water pump delete kit???

    Just wondering if anyone makes a water pump delete kit....Would like to go with an electric pump and do away with the oil cooler and pipe that runs just above the exhaust manifold....I know powermax makes a kit but I have been having trouble getting ahold of him....thanks
  16. straightpiperoar

    4X4 With an engine girdle

    I have heard that there is a problem with the centerlink hitting on the oil pan on 4x4 models with an engine girdle...Is this true and what have some of you guys done to fix the problem....thanks mike
  17. straightpiperoar

    New Turbo... Just Don't Know Who Its For

    Here are a few pics of the Turbo jpowel29 just got..... In the first picture that is a true traffic cone.....That turbo is huge!!!!!!
Top Bottom