Duramax Diesels Forum Truck of the Week


Go Back   Duramax Diesels Forum > Search Forums

Showing results 1 to 25 of 500
Search took 0.02 seconds.
Search: Posts Made By: MAXX IT OUT
Forum: Stereo & Electronics 10-19-2018, 10:42 AM
Replies: 7
Views: 332
Posted By MAXX IT OUT
Thanks

Thanks
Forum: Stereo & Electronics 10-19-2018, 06:31 AM
Replies: 7
Views: 332
Posted By MAXX IT OUT
Well just to update everyone that is interested,...

Well just to update everyone that is interested, I ended up rolling under the truck to find that someone had replaces the NSBU plug and that a couple of wires had burnt out between the splice and the...
Forum: Repower / Transplant 10-16-2018, 05:49 AM
Replies: 40
Views: 3,158
Posted By MAXX IT OUT
A couple of questions, is that a Scott's Hot Rods...

A couple of questions, is that a Scott's Hot Rods front IFS and how far did you did you set back the engine? Was setting the engine back so you had more room for the cooling stack or was the Allison...
Forum: Stereo & Electronics 10-12-2018, 08:07 AM
Replies: 7
Views: 332
Posted By MAXX IT OUT
I found this on DP "This info applies to...

I found this on DP


"This info applies to 2001/2002 model years. Not sure about other years.
Here's a few of the signal generated from the NSBU. There may be more.

-Electronically tells...
Forum: Stereo & Electronics 10-12-2018, 07:55 AM
Replies: 7
Views: 332
Posted By MAXX IT OUT
Yep Josh its the 01 and thanks for the diagram. I...

Yep Josh its the 01 and thanks for the diagram. I will see if I am getting voltage to the NSBU Switch. Is there another symptoms that can tell me that the NSBU switch is bad?
Forum: Stereo & Electronics 10-12-2018, 06:31 AM
Replies: 7
Views: 332
Posted By MAXX IT OUT
Reverse Lights and the BCM

Long story short my reverse light are not getting power at the under hood fuse block, if I probe the fuse with power the lights work. Does the BCM control power supply to the fuse or is there a...
Forum: Turbo Talk 10-01-2018, 05:50 AM
Replies: 1
Views: 158
Posted By MAXX IT OUT
The exhaust inlet Flange to the top of the...

The exhaust inlet Flange to the top of the compressor housing is a tad under 9 inches and the top of my pedestal is 3 inches above the top of my up pipe flange. I can not lower the turbo much more...
Forum: Duramax Engine Building 09-25-2018, 08:31 PM
Replies: 41
Views: 1,284
Posted By MAXX IT OUT
James, how much of that 600+ HP do you think you...

James, how much of that 600+ HP do you think you use when towing. Granted you have twins, more aerodynamic drag, long grades and altitude to deal with, which increases load on everything. I am...
Forum: Duramax Tuning, Logging, and Gauges 09-23-2018, 05:33 PM
Replies: 3
Views: 221
Posted By MAXX IT OUT
What's the new data logging system? I didn't know...

What's the new data logging system? I didn't know that they had changed anything.
Forum: Duramax Tuning, Logging, and Gauges 09-23-2018, 04:32 PM
Replies: 3
Views: 221
Posted By MAXX IT OUT
Best Monitor System

Well my Edge CTS2 got stolen out of my truck last week, So I am shopping for a new monitor. I used it to monitor everything from fuel temp to main injection timing as well as my external boost, drive...
Forum: Duramax Tuning, Logging, and Gauges 09-18-2018, 06:34 AM
Replies: 737
L5P: L5P Tuning
Views: 79,046
Posted By MAXX IT OUT
So how much of a Band aid is the stock DPF?

So how much of a Band aid is the stock DPF?
Forum: Duramax Tuning, Logging, and Gauges 09-18-2018, 05:56 AM
Replies: 737
L5P: L5P Tuning
Views: 79,046
Posted By MAXX IT OUT
That truck smokes more than my mine. Great way to...

That truck smokes more than my mine. Great way to release a product, Get GM, the EPA, and all the nut jobs all worked up and on our case more than they already are.:(:confused:
Forum: Smoke Signals 09-07-2018, 12:40 PM
Replies: 2,553
Views: 210,899
Posted By MAXX IT OUT
You Could drop that off at my house, I have...

You Could drop that off at my house, I have always wanted one of those. Is it a auto or a Manual?
Forum: Introductions 09-02-2018, 04:50 PM
Replies: 6
Views: 1,002
Posted By MAXX IT OUT
What part of Iowa are you from?

What part of Iowa are you from?
Forum: Turbo Talk 08-29-2018, 06:09 AM
Replies: 15
Views: 1,811
Posted By MAXX IT OUT
What would everyone think is high for Drive...

What would everyone think is high for Drive pressure on a single S36X turbo? I Just swapped to a S369 from a older S366 and jumped about 8 PSI on drive pressure from swapping the clipped turbine to...
Forum: Smoke Signals 08-17-2018, 07:50 AM
Replies: 413
Views: 91,366
Posted By MAXX IT OUT
I Guess someone now has as quad turbos up and...

I Guess someone now has as quad turbos up and running. Interesting setup to say the least.
https://www.instagram.com/p/BmkSwrkhSR-/?utm_source=ig_share_sheet&igshid=1k3015l4aznuy
Forum: LB7 07-25-2018, 09:01 AM
Replies: 7
Views: 369
Posted By MAXX IT OUT
I guess I will give those bolts a try, I also...

I guess I will give those bolts a try, I also order some ARP bolt 12 points bolts for the valve cover. I am getting tired of GMs using crappy grade hardware, I don't think they intended them for...
Forum: LB7 07-25-2018, 07:58 AM
Replies: 7
Views: 369
Posted By MAXX IT OUT
Upgraded injector fuel return lines

Currently I am pulling mine valve covers apart to replace a injector on the passenger side, along with the valve cover gasket on the driver side and decided to do a retorque then lash the valves....
Forum: The Tool Crib 05-31-2018, 06:54 AM
Replies: 30
Views: 2,366
Posted By MAXX IT OUT
What about Asymmetrically or Symmetrically and 2...

What about Asymmetrically or Symmetrically and 2 or 3 stage arms?
Forum: The Tool Crib 05-30-2018, 10:41 AM
Replies: 30
Views: 2,366
Posted By MAXX IT OUT
Vehicle Hoist

I am looking at getting another hoist in the shop, so I can work on multi able projects at the same time and be able to safely hold heavier trucks. I currently have a 7000 LBS 2 post hoist that I...
Forum: Turbo Talk 05-14-2018, 06:19 AM
Replies: 15
Views: 1,811
Posted By MAXX IT OUT
Well I finally got around to installing the...

Well I finally got around to installing the housing this weekend. First impressions, it defiantly lights sooner, but it didn't make as big of a differences as I expected. I think Tony has my tuning...
Forum: Stereo & Electronics 05-07-2018, 10:57 AM
Replies: 2
Views: 175
Posted By MAXX IT OUT
Mine does it randomly and generally is for a...

Mine does it randomly and generally is for a second then going back to normal, sometimes I lose everything but RPM, Speed, and Oil pressure, the fix for that for me is to either pull the cluster out...
Forum: Smoke Signals 05-07-2018, 06:58 AM
Replies: 91
Views: 4,434
Posted By MAXX IT OUT
Does anyone know what the big cummins guys are...

Does anyone know what the big cummins guys are running for engine set up's these days? Deckplated and sleeved 6.7 down to 5.9, billet blocks, billet cranks, aftermarket heads? I am just curious to...
Forum: National Events 04-09-2018, 09:31 AM
Replies: 71
Views: 15,406
Posted By MAXX IT OUT
The reason for Firepunks success at these events...

The reason for Firepunks success at these events is they have done the hours and hours of testing before the event. So when they show up they know the truck has gone mid 8's regularly, and make the...
Forum: Repower / Transplant 04-06-2018, 08:23 AM
Replies: 4
Views: 604
Posted By MAXX IT OUT
Duramax/4L85E wiring

How do the factory vans run the 4l85E? I have finally found a engine and trans for my c10 swap, but it doesn't have the ECU's or body harness. How different is the van harness from the truck harness?...
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT -7. The time now is 10:48 AM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2018, vBulletin Solutions, Inc.
vB.Sponsors