Recent content by WisconsinHick1

  1. WisconsinHick1

    2wd Street tires?

    Run street slicks. I ran Nitto's and Toyo's in my old 2wd drag truck and couldn't get them to hold on the street.
  2. WisconsinHick1

    Floor-It Pump Help

    Yes you can James I sold my Duramax pump to a friend with a Cummins. Swapped out a few fittings and your good. I was planning on going dual pumps with Cummins fittings at one point but never made it that far.
  3. WisconsinHick1

    Floor-It Pump Help

    My guess is it's a Cummins pump with a Cummins FCA. But you can use it. I would recommend using a new Duramax FCA to make tuning easier. Where are the low pressure fuel feed and the high pressure fuel supply ports? I know the Cummins rail supply is coming out the back of the pumps.
  4. WisconsinHick1

    PPE OE Style Centrelink

    I have had trucks with straight center links and you do not lose a lot of turning radius. You lose a little bit of your turn radius.
  5. WisconsinHick1

    03' GMC SoCal stroker

    There is a sled every weekend you just have to decide which one you want to attend. :D
  6. WisconsinHick1

    Screw in injector cups....Oooooooo shiney

    Message sent.
  7. WisconsinHick1

    Pinned oil pump

    What do they run for pressure? I might have to consider more oil pressure on the new motor.
  8. WisconsinHick1

    EFILive Custom efilive v2 cases?

    I have a Pelican style hard sided case from Harbor Freight that my V2 and HPtuner setup live in. If they aren't in my bag to tune they are in my gun safe for storage.
  9. WisconsinHick1

    Remote Oil Filter Setup?

    Thank you sir. As long as I can get 90 degree fittings on there it should be short enough to clear. I have about 3" between filter housing and mid engine plate.
  10. WisconsinHick1

    Remote Oil Filter Setup?

    Josh any chance you could grab a couple measurements for me? Mainly just looking to see how tall it is? Or how far it sticks out from the housing?
  11. WisconsinHick1

    My New Project

    If all goes well I should be rolling the chassis back into my garage in a month or so!
  12. WisconsinHick1

    Need some insurance insight

    More expensive repair costs in newer diesels, they cause more damage because of there size and so on. I do know there was a company if I heard correctly have a 15-20% increase in premium across the board for auto's but again I don't know if that was nation wide or state to state or what. Again I...
  13. WisconsinHick1

    Lb7 build

    I would guess around 12k-15k before air and fuel.
  14. WisconsinHick1

    Lb7 build

    Honestly I don't count anymore between a third set of injectors third turbo and so on. It is really tough to put a number to it as its also been over about 5 years now.
  15. WisconsinHick1

    Lb7 build

    Whatever you think your budget is add 5k for cushion. I wish I wouldn't of built my motor and saved the headache now I'm too deep too look back now lol.
See more
Top Bottom