Recent content by supernat10

  1. S

    Vane Position Sensor Readings

    Thanks, it actually smoothly moves from 100 to 0. But once I get to 0, if I keep pushing it in, for a small time it stays at 0, then jumps to 100 near fully depressed. Just didn't know if that was correct. It could well be causing the learning process to fail. Will be looking at it more this...
  2. S

    Vane Position Sensor Readings

    Thanks Ron. I know what the code means, just wasn't sure if the sensor should be jumping back to 100% a short distance after the plunger hits 0%. I actually reinstalled the sensor today and connected my Autel to watch live data. The "learning" flag was "in progress" the entire time, and...
  3. S

    Vane Position Sensor Readings

    Hey everyone, been getting P003A, so I pulled off my vane position sensor and did a manual plunge on it. Readings on my Autel MX808 show the position start at 100%, pushing in a short distance before it starts to linearly move down to 0%, then a short distance later jumps to 100% for a good...
See more
Top Bottom