Ron Nielson's latest activity
-
RRon Nielson replied to the thread 2002 FE9.What pinion shim angle did you use?
-
RRon Nielson replied to the thread In need of a little assistance..Maf is very low as previously posted. should be about 40 gm /sec at a warm idle in park. If yours is 17 GM /SEC at idle, start by...
-
RRon Nielson replied to the thread Brakes refuse to bleed properly .Bleeders at the top??
-
RRon Nielson replied to the thread Rear pinion seal.Yes, most people don't do the job correctly, but it usually turns out ok.
-
RRon Nielson replied to the thread Rear pinion seal.13 - Pinion Seal 26064029 $39.18 10.50, 11.50 Is this the part you used?
-
RRon Nielson replied to the thread 09 LMM white smoke.See this attachment. Chevrolet-GMC Diesel Diagnostics
-
RRon Nielson replied to the thread Fuel rail pressure.A hose clamp put over the kinked area, not too tight, will 'stop the kink' and restore the flow.
-
RRon Nielson replied to the thread Lml piston install.Don't forget a good aftermarket balancer.
-
RRon Nielson replied to the thread 2002 LB7 pinouts.https://charm.li/Chevrolet/2002/ You may have other questions.
-
RRon Nielson replied to the thread 2500 vs 3500.Note that whatever you decide, keep in mind that a long-bed truck is very stable when towing.
-
RRon Nielson replied to the thread New to dramas.Maybe some help here
-
RRon Nielson replied to the thread 2500 vs 3500.Slightly larger tires (265's vs 245's) and wider wheels (1/2 inch) on the 3500, at least on my 2008 model
-
RRon Nielson replied to the thread 2009 Lmm delete kits.When you buy a new-to-you truck, it's always best to drive it for a while, maybe a year or so, to make sure it is going to be reliable...