Recent content by Josh281

  1. J

    Help Truck Won't Start

    UPDATE: Tried all the suggestions you guys posted with no luck. I did end up finding out that I have really low rail pressure. I've been on the phone with Wehrli who had the same thing happen after one of their installs. They ended up doing a CP3 conversation and it started. Also waiting for...
  2. J

    Help Truck Won't Start

    I will try all the above methods after work and report back. Thank you to everyone that has replied to this thread so far. Keep the ideas coming and I will try them all in a couple of hours.
  3. J

    Help Truck Won't Start

    We tried that yesterday for sometime. Felt like I was giving CPR. I did notice that when I would pump on the primer it did get pretty firm. Then when I had someone start the truck while still pumping on it, it immediately went spongy and stayed that way while cranking. Also I could prime...
  4. J

    Help Truck Won't Start

    We primed the truck several times with the primer and using the set screw. On average we cranked the truck three (3) times until the truck timed out on cranking. We would then prime it again and start the process over again. I did crack the lines on two (2) injectors. The first injector had...
  5. J

    Help Truck Won't Start

    Mechanic said rail pressure was .5mpa
  6. J

    Help Truck Won't Start

    I also forgot to mention this is a 2011 LML with 192K miles.
  7. J

    Help Truck Won't Start

    No I don't have a lift pump.
  8. J

    Help Truck Won't Start

    I installed the Exergy CP4 Fuel System Saver the other evening which consisted of pulling the stock Fuel Pressure Regulator out and replacing it with the one from Exergy. After the install the truck will not even try to fire, it only turns over. I only pulled off the AC Compressor for the...
    • Josh281
    • Thread
    • Replies: 20
    • Forum: LML
See more
Top Bottom