Recent content by John Noonan

  1. John Noonan

    Help: Towing 911!! July 7 845pm

    What did you do to determine it was the EGR Cooler? J
  2. John Noonan

    Help: Towing 911!! July 7 845pm

    Any new updates on what was found?
  3. John Noonan

    LLY: 2006 LLY Cold Start Alternator Output Problems

    Rebel, Thanks yes I saw there are two and they seem to be close to each other, with work and travel and still healing from a very fast motorcycle crash I am kind of limited on what I can do with my right hand and being that I'm right handed it makes work tough. How long does it take to...
  4. John Noonan

    LLY: 2006 LLY Cold Start Alternator Output Problems

    When mine is cold at start up the volt meter shows about 11.5 volts..then after a few minutes it tops at 14 volts..the problem is I work only a few minutes away so the truck is not warming up fully before I get to work. I have the check engine light on and after reading the code it shows...
  5. John Noonan

    LLY: 2006 LLY Cold Start Alternator Output Problems

    Any updates on this....?
  6. John Noonan

    CA smog 2010

    Any updates on this Cali smog situation? I have the stock exhaust cut up however... John
  7. John Noonan

    LBZ: Rods So many choices

    Well after swearing off of making Dmax rods I have been quoted just under $10,000.00 for the tooling/forging die. I can see why some companies may have started up by charging more in the beginning (to recoup the die/tooling cost perhaps) however I would think that if the rods are what I think...
  8. John Noonan

    LB7: Finding a boost leak

    If you need to borrow the testing caps send me a PM. Good luck. John
  9. John Noonan

    LB7: Front end noise?

    Is this Bushing/bearing in the shaft that Pat is talking about? Something I can do at home? John
  10. John Noonan

    LB7: Front end noise?

    Pat thanks, Anyone else..? Any test or part removal I can do to check for? J
  11. John Noonan

    LB7: Front end noise?

    On Michelle's 2003 LB7 she has been in to the dealer 5 times for a "steering shaft replacement however I believe a few of the times it was just "lubed" and not replaced. You can see from link what was done before. http://www.duramaxdiesels.com/forum/showthread.php?p=113171#post113171 The...
  12. John Noonan

    LBZ: Rods So many choices

    The rods and pistons in the picture are for a Nitro Top Fuel car and are what appears to be either a Howards or most likely a Brooks Aluminum rod and a hard anodized JE or Venolia piston..but what do I know I work for a company based in Germany.. :) J
  13. John Noonan

    LBZ: Rods So many choices

    I'll tell you what, since there seems to be some keyboard jockeys here that are so against another rod company coming in to this market and taking part of this great site I will no longer talk about the rods here to please the few whining members that seem to continue to bash this attempt to...
  14. John Noonan

    LBZ: Rods So many choices

    The rod is made stronger and the same material is used...:thumb: With your thinking picture a thinner impact socket that would fail after a few uses, then make it from the same material and design it better with more material in the previously failed area. John
  15. John Noonan

    LBZ piston weight:

    :thumb:
See more
Top Bottom