Recent content by Harbin_22

  1. Harbin_22

    1/4 mile discussion and time slips post here!

    This is a totally different truck than what the one was that went 10.12 at 6860. This is a reg cab 5400ish# LMM. Mark was thinking it was on this list, but it's only on the 1/8 list.
  2. Harbin_22

    1/8 mile discussion and time slips post here!

    Hey James, sorry to bug, but you didn't put mine on the list buddy.
  3. Harbin_22

    1/8 mile discussion and time slips post here!

    Ohio Valley Raceway in Louisville KY
  4. Harbin_22

    1/8 mile discussion and time slips post here!

    Well it's no where near as nice or quiet ?. But really it does feel good to have a legit race vehicle with all the safety stuff. It's much easier to work on too. Nice going to the track and not worrying about getting booted. It's going to be a continuous project with no real goals in mind...
  5. Harbin_22

    1/8 mile discussion and time slips post here!

    This my new truck. Think this was the 5th pass it has made. Reg cab 4x4 LMM 5400ish# Allison Mark's tuning 9-17-21 Just read through the thread and saw Mark had already posted. Thanks buddy!
  6. Harbin_22

    Mobil M1-303A Filter Differences

    Relief valves are totally different too. I hate when they change stuff and give no information out about it.
  7. Harbin_22

    Mobil M1-303A Filter Differences

    I'll figure out how to post pics, but I have used the Mobil M1-303 oil filters on my truck forever. I know they changed to the M1-303A extended performance a while back. Well I picked a few more since I was using up my last one and they are different from the M1-303A I already have. The...
  8. Harbin_22

    LMM Mega Fuse Wiring Layout

    Thank you! Exactly what I needed. Looks like I was I am in good shape the way I have it.
  9. Harbin_22

    LMM Mega Fuse Wiring Layout

    I still run two batteries and glow plug controller, but no grid heater.
  10. Harbin_22

    LMM Mega Fuse Wiring Layout

    Happen to remember where the alternator wire goes?
  11. Harbin_22

    ECT readings vs. gauge temp readings after tune

    So you know, only the early LMM had two sensors. Not sure when the changeover was, but my 2010 only has one
  12. Harbin_22

    LMM Mega Fuse Wiring Layout

    I've saw that pic on google, that's what I need, plus what each wire is going to/from
  13. Harbin_22

    LMM Mega Fuse Wiring Layout

    Could some point me in the right direction, or look over their mega fuse panel on an LMM and tell me what wires are where. I changed mine around years ago to make room and really wondering if I have it setup any way at all like it is supposed to be lol.
  14. Harbin_22

    LBZ: ATI damper seems to small? Honing needed?

    I had my machine shop take a few thousands out of my hub lol. Was tired of fighting with it. Takes a little pressure to take it on and off now, but with a keyed crank, not worried about being such a tight fit
  15. Harbin_22

    wagler mechanical belt tensioner

    It's so crazy that I have never had a single issue with belts coming off. I've had a PPE dual fueler kit for probably 50k miles of constant beating lol. Even has a 10mil for the top pump
See more
Top Bottom