Suncoast trans. problem

[DrtyMax07]

Just installed a transmission built by suncoast and i have no gears. Have codes PO877, PO761, PO751, PO701. Any ideas? Thanks.

 

[DrtyMax07]

Fluid level is at bottom of hot mark too.

 

[dmax711]

Make sure everything's plugged in 100%, free of dirt/debris and no fluid. If all is fine then I'd pull plug on harness that goes to trans and see if it goes into hyd. Limp.

 

[DrtyMax07]

double checked and all plugged in and good. have 150psi at idle

 

[Mike L.]

How many quarts did you put in? The TCM is reading no fluid in the valve body.

 

[DrtyMax07]

figured it out

 

[Mike L.]

What was it?

 

[Muff]

What was it?

X2

 

[DrtyMax07]

check your PM's

 

[DrtyMax07]

above meant for Mike

 

[DrtyMax07]

close thread please

 

[PACougar]

You gotta at least tell us what the problem was.

 

[DBUSHLB7]

You gotta at least tell us what the problem was.

Prob embarrassed to say it was low on fluid the whole time. Maybe his dipstick tube wasn't seated down far enough???? Guess we will never know

 

[PACougar]

Prob embarrassed to say it was low on fluid the whole time. Maybe his dipstick tube wasn't seated down far enough???? Guess we will never know

That was my first thought, but I love a mystery.