NorCal large fender mod help

[Rancelot211]

 

[Rancelot211]

Not sure why but I didn't seem to move my fender as much as other pics I have seen not sure if someone could give
Me some tips or pointers. Truck is leveled with 305 55 20s on -19 mm offset. Lock to lock I barely rub unless in reverse and would like to fix that.

 

[BLACKMAX1]

Looks like yours isn't folded in as far, my tires rub as well "305/50/20, -19 20x10" and am slightly higher than stock. I'll take some pictures of mine when I get off work.

 

[Nathan.]

I did the same to mine. Im leveled with 33x12.50R20 with a -24 offset. Mine dont rub at all.

 

[Hernpj01]

is it rubbing the metal or fender liner?

 

[clrussell]

There's at least a couple more inches there to trim


Sent from my iPhone using Tapatalk

 

[clrussell]

I cut mine all the way to the bolt. This side doesn't have an inner fender yet because I'm lazy..

Passenger side with inner fender

Clearance on driver side

Sent from my iPhone using Tapatalk

 

[clrussell]

285/55/20 tires on 20x12 -44 with no torsion bolts..


Sent from my iPhone using Tapatalk

 

[RPM Motorsports]

Did you cut it or just pound it in with a hammer?
http://norcaltruck.com/index.php/component/com_ixxocart/Itemid,591/id,2046/p,product/parent,161/

 

[OregonDMAX]

Psssh ridiculously negative offset wheel problems, aint nobody got time for dat.

 

[Nathan.]

If your tires still rub you didn't use a big enough hammer!

 

[Rancelot211]

I made all the cuts. That's why I don't understand why it won't go back any further.

 

[clrussell]

If your tires still rub you didn't use a big enough hammer!

This


Sent from my iPhone using Tapatalk

 

[clrussell]

I made all the cuts. That's why I don't understand why it won't go back any further.

Can you get me a better pic of yours? I might be able to explain a couple things I do to make it work.


Sent from my iPhone using Tapatalk

 

[Rancelot211]

Have an email bud?

 

[Nathan.]

Before I busted out the hammer I used a floor jack and a 2X4. Not sure if that helps at all but it seamed to help me get the bending process headed in the right direction.