Lly hsp y bridge?

[tbarn33]

I have a hsp 3 inch bridge for my lly and it has a muting tab on it that I'm trying to figure out what is supposed to bolt to it. First picture is a whole picture of the bridge and the second is of the bracket I'm talking about thanks.

 

[countrycorey]

MAP Sensor


Corey

 

[duramaxzak]

I have a hsp 3 inch bridge for my lly and it has a muting tab on it that I'm trying to figure out what is supposed to bolt to it. First picture is a whole picture of the bridge and the second is of the bracket I'm talking about thanks.

It's for a MAP sensor.

 

[tbarn33]

Is it for if your using an aftermarket one for data logging or something then? I didn't have any wires or sensors left over on the install.

 

[countrycorey]

It's for your factory MAP sensor, it bolts to that just like it was bolted to your factory bridge


Corey

 

[Chevy1925]

It's for your factory MAP sensor, it bolts to that just like it was bolted to your factory bridge


Corey

Factory lly is in the intake runner like the Cali emission lb7

OP, you will need to plug it off. It's for a map sensor like said before but only federal emission lb7s use that spot.

 

[countrycorey]

Factory lly is in the intake runner like the Cali emission lb7

OP, you will need to plug it off. It's for a map sensor like said before but only federal emission lb7s use that spot.

Learn something every day. Thanks James!


Corey

 

[onebaddmaxxx]

Factory lly is in the intake runner like the Cali emission lb7

OP, you will need to plug it off. It's for a map sensor like said before but only federal emission lb7s use that spot.

No need to plug it off. It is solid and you have to drill it if you plan on using it. Otherwise leave it alone.

 

[DaveB]

No need to plug it off. It is solid and you have to drill it if you plan on using it. Otherwise leave it alone.

That is correct. It's for the MAP sensor. The through hole in the block is not drilled so if you don't need it no worries at all!

 

[tbarn33]

OK thanks guys I noticed it wasn't drilled through so I wasn't sure if there was some support that was supposed to bolt to it or what the deal was.

 

[Chevy1925]

No need to plug it off. It is solid and you have to drill it if you plan on using it. Otherwise leave it alone.

Even better!