So I had to swap ecms chasing a fuel temp code. Now I am getting po2cd cyl 1 injector exceeded learning limit.
I wrote down and confirmed in ecm and gpm the injector calibration #s in programming.
Balance rates are crazy good.
I'm at a loss I don't see it being an injector and there's no mechanical issue.
Can these codes be programmed out with my ezlynk programmer?
What else can I check...
I wrote down and confirmed in ecm and gpm the injector calibration #s in programming.
Balance rates are crazy good.
I'm at a loss I don't see it being an injector and there's no mechanical issue.
Can these codes be programmed out with my ezlynk programmer?
What else can I check...