Duramax Diesels Forum Truck of the Week
  #1  
Old 05-25-2018, 06:15 AM
r_olsen r_olsen is offline
AZDmax
 
Join Date: Nov 2017
Location: Arizona
Posts: 18
Question P2202-p2203 - NOx sensor

Had these two codes show up a few days ago, looks like they refer to the upstream NOx sensor which is easily replaced, but was noticing on my CTS2 that the soot level was building and pasted 44 without a regen. Last night it was at 50 when the DIC showed the message "Cleaning exhaust filter - keep driving...", after about 10 minutes it cleared and the soot level dropped to 47, this continued for the next 30 minutes with the soot level eventually getting up to 60g, then doing the clean exhaust filter and coming back down to 49-50. After three of four of these cycles it then threw a P0420 code which I assume is related to the bad NOx sensor? Question is since I have the CTS2 will doing a manual regen take care of the soot issue until I can get the new NOx sensor installed later today or tomorrow and then see if all is OK, or would it be better to wait till the sensor is installed then do the regen? Also anyone know what size wrench to use to remove the NOx sensor?
__________________
2012 GMC 2500HD Denali LML
Edge Evolution CTS2
No mods....yet

Last edited by r_olsen; 05-25-2018 at 02:57 PM.
Reply With Quote
Reply


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -7. The time now is 09:01 AM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2018, vBulletin Solutions, Inc.
vB.Sponsors