View Single Post
Old 05-16-2018, 11:59 PM
scramHD's Avatar
scramHD scramHD is offline
"2 pints of booze"
Join Date: Aug 2008
Location: Tx / MS / AL / MEX
Posts: 97

After flattening my stock leafs I chose General Springs 4200lb HD springs as I carry heavy loads and tralers full of stuff most of the year to jobsites. Big difference in ride when loaded down. Seems like the more I put on them the better they ride. They are stiff unloaded but still ride and handle superb. I prefer my suspension set up more firm than some do and so far so good with these. Shipped to me aprox 550 I think. Been on truck for over a year and a squeek from a bushing is heard every now and then but still ride as new, look new and level. Ive yet to get them to squat more than a half inch lower than the front with a fully loaded bed and 7x12 utility trailer packed to the roof with tools, materials, concrete, and equipment.
02 LB7, cc/sb 2wd
EFI LiveV2/Neens/ATS/SoCal/PPE/SuperDiesel/Industrial Injection/TrentNell/MFrank/TTS/-McRat--Kat-/Dan

15.5 LML cc/sb 4wd
Zone 5"/ Fox 2.0 Resi / 4k lb rear leafs
Kryptonite UCA's/WB's/LBJ's
Cognito PISK / SB end links / Kryptonite tie rods
63.5mm 6+6 / AD 165 4g / sump by Ohio Diesel
Mishimoto hot & cold intercooler pipes / 4" CAI by me
3" MBRP downpipe / 4" ex / Magnaflow 20"
DEI heat wrapped ex / hand polished factory tip by me
Revmax Billet Triple / vb mods & T87 tuning by me
E86b Ridgerunner / EFIv2 / l25hp / 75hp / mOOnshine
Autometer pod / oil temp / boost / CTS2
Bora 1.5" / 18s / 295/70

12 yz450f[
polished frame/swingarm by hand by me
GYTR head / Cycra powerflo / Flo motorsports/ Vortex bars / Ascerbis X seat / ASV shorty levers/
Bazzaz Tuning/Logging /SCAR racing / Scorcher SS header /HotCams / Twin Air

05 BMW e46 325i sport
m56 engine / sachs / camber kit
lowered / tuned / CAI by me / -pcv
Reply With Quote