View Single Post
  #3  
Old 10-10-2019, 05:34 AM
Bdsankey's Avatar
Bdsankey Bdsankey is offline
Gearhead


 
Join Date: Feb 2018
Location: Neenah, Wisconsin
Posts: 1,188

Default

Are you planning on incorporating the loop-and-pull through method like these blankets show or the same mounting style as previous?


I'm going to end up needing a set once I get my LB7 back on the road (bearing damage so its getting new main/rod bearings, oil pump etc) with compounds. I do need to hit you up about what is going to be the best option for heat protection on the downpipe.
__________________
Current Rides:
1) Toy: 2005 LLY ECSB, Leather, Sunroof
-1340hp/2200ft-lbs @ ATS Diesel (06/04/19)
-Tuned by Zach @ Starlite
-Built Motor, Forced Inductions Billet ETR Gen 4 S480/96/1.10 T6 w/V2 Race Cover, Modded Exergy 250% Injectors, Exergy 14mm Street Pump/LBZ CP3, Goerend Q Converter, Billet Trans, Fuelab Supply Pump/Reg, RCD & Beans Sumps, Front E-Locker, TrueTrac, Yukon 4340 Rear Shafts, Traction Bars, DHD Center Link Brace, DHD Lower Crossmember Support, Banks iDash 1.8 Monitoring System

2) DD/Tow Rig: 2002 LB7 CCSB, Leather, Loaded
-Tuned by Starlite
-Cast S475/96/1.10 T6 Over Stock IHI, FASS 150,4" Exhaust, RCD Sump, PPE Sleeves, DHD Centerlink Brace, DHD Lower Crossmember Support, Steering Wheel Radio Control Swap, LML Oil Pump, LML Piston Cooling Nozzles, 2020 L5P Oil Cooler, Derale Aux Oil Cooler w/Fan, Banks iDash 1.8 Monitoring System
Reply With Quote